Elemental
of the periodic table.
-
Product
Conductivity Type Tester
HS-HCTT
-
It is strictly designed according to the requirements of the hot-probe thermal EMF conductivity type test in standard ASTM F42: Standard Test Methods for Conductivity Type of Extrinsic Semiconductor Materials. A temperature controlling heating element is installed inside the hot probe so that the hot probe is heated automatically and its temperature is maintained in the range 40-60℃.
-
Product
Commercial Panel Controls
-
Panels controls are designed for applications that typically require frequent adjustment. Both rotary and slide panel control types are available. A selection of elements includes carbon, cermet, and conductive plastic. These devices are available in various sizes and shaft/bushing combinations. Some models are available with a rotary switch and seal options.
-
Product
Electrical Grounding Analysis
GroundMat
-
SKM GroundMat is a program for substation ground grid design and analysis. It is designed to help optimize grid design or reinforce existing grids of any shape. It uses a general-purpose finite element algorithm for potential analysis and graphical facilities to validate ground system efficiency
-
Product
Inductively Coupled Plasma Spectroscopy (ICP-OES/MS), ICP Analysis Services
-
ICP-OES measures the light emitted at element-specific characteristic wavelengths from thermally excited analyte ions . This light emitted is separated and measured in a spectrometer, yielding an intensity measurement that can be converted to an elemental concentration by comparison with calibration standards. ICP-MS (ICP-Mass Spec) measures the masses of the element ions generated by the high temperature argon plasma. The ions created in the plasma are separated by their mass to charge ratios, enabling the identifcation and quantitation of unknown materials. ICP-MS offers extremely high sensitivity (i.e. low detection limits) for a wide range of elements
-
Product
Thermal-Optical Analysis
-
As with other current organic carbon and elemental carbon (OC/EC) procedures, Thermal-Optical analysis is method-defined. However, this unit has been designed to specifically address some of the problems observed in other methods in assigning carbon to either the organic or the elemental fraction.
-
Product
Virtual SBC
-
What is a virtual session border controller or virtualized SBC? Traditionally, a session border controller (SBC) is a device positioned between carrier networks or between an enterprise LAN and a service-provider WAN. In the latter case, the border controller is called an enterprise session border controller or eSBC. Whether it is delivered as a dedicated hardware session border controller or a virtualized network function, (a.k.a. software SBC) the border controller manages call (session) setup and teardown. The SBC also provides network demarcation (demarc), or separation (border) between network domains, as well as other types of management (control) over the data streams that pass between networks. With the growing popularity of software defined networking (SDN) and the burgeoning market development and adoption of network function virtualization (NFV), eSBC functionality is more and more often de-coupled from a dedicated hardware device and delivered as a virtual instance running as a virtual machine (VM) on top of a hypervisor. It is generally not well understood in the market why an eSBC is such a critical network element for a secure and reliable SIP-based enterprise phone system. The following publication will help close that knowledge gap.
-
Product
On-site Oil Analyzer
MicroLab 30
-
MicroLab 30 is designed for fleets operating over-the-road vehicles or generator equipment. This analyzer best suited for companies interested in testing primarily engine oils to determine the serviceable life of the oil and the equipment condition. The MicroLab 30 analyzes six oil chemistry parameters along with viscosity to determine proper drain intervals. The standard 10 element version provides information on oil contamination and wear metal analysis to determine if mechanical issues exist. The MicroLab 30 can be upgraded to 20 elements if there is an interest to analyze oil additive levels as well as additional wear metals.
-
Product
Radar Test System
UTP 5065
Test System
Radar sensors are core elements to realize autonomous driving. The UTP 5065 radar test system from NOFFZ Technologies has a compact vertical design and contains everything needed to allow State-of-the-Art measurement and sensor calibration. The test bench setup and component selection are tuned to get best possible results for highly accurate and cost-efficient testing in production of automotive radar sensors.
-
Product
Surveying System for Schools
TECOL
-
F. W. Breithaupt & Sohn GmbH & Co.KG
*Modular system with visible central elements*Theodolite, level and alidade*Didactical design for education*Scope to be plunged both ways with scope level*20x magnification*Reading 0,1°*Vertical circle with additional %-graduation*Made in Germany
-
Product
Mentor Components (US Only)
-
The portfolio of Mentor components includes LED-based lighting systems for ambient and functional lighting as well as modern operating and display elements for housing fronts and other mechanical, electronic and optoelectronic components from the HMI sector. While the focus used to be on components, our range is now increasingly developing into complete systems and subsystems. These solutions are usually developed and manufactured according to the customer’s needs. From design to manufacturing: All from a single source.
-
Product
Inline Test Stations
-
Computer Gesteuerte Systeme GmbH
Test-specific contacting elements (upper and lower cassettes) which are inserted into the insertion device of the test headClamping device per cassette for fastening (pneumatic clamping set)
-
Product
Detector Test Bench
RTB 3000
-
The RTB 3000 Detector Test Bench from Santa Barbara Infrared (SBIR) is a flexible integrated IR detector test station for evaluation of single element detectors, linear arrays, and focal plane arrays. The RTB 3000 provides the radiometric stimulus necessary to perform accurate IR detector testing in both laboratory and production environments.
-
Product
Material Thickness
-
The Elcometer range of ultrasonic material thickness gauges has been designed specifically to be easy to use, calibrate, take readings and create inspection reports. With a wide range of measurement modes including: Pulsed Echo (PE), Echo Echo ThruPaint™ (EE) and Velocity Mode (VM), and a wide range of intelligent dual element transducers, the new ultrasonic non destructive thickness gauges can measure the material thickness of virtually any material such as metals, plastics, glass, epoxies and ceramics.
-
Product
Oxygen/Nitrogen/Hydrogen Analyzer
EMGA-930
-
This is a simultaneous oxygen, nitrogen & hydrogen elemental analyzer with high accuracy and repeatability suiting to cutting-edge technology's R&D as well as quality control in the market of steel, new materials, catalyst and so on. This is a new generation model optimized to fit to user's requests.The oxygen is measured as carbon monoxide and carbon dioxide by two non-dispersive infrared detectors, the nitrogen by a thermal conductivity detector and the hydrogen with non dispersive Infra Red detector as H2O.
-
Product
Functional test
-
Maschinenbau Haldenwang GmbH & Co. KG.
Test bench for small vehicles with 2 wheelsRoad load simulationDetermination of maximum speedMeasurement and evaluation of speed, speed, distance traveledDisplay of wheel power at test speedDisplay on your PC monitorExpression of test resultsCustomer and vehicle databaseEuro system console MCD 2000 with switching elements for roller setPort for external devices
-
Product
Power Entry Modules
-
Simplifying the power entry element in an electrical or electronic product with a module can help make the assembly easier and may benefit a company in product design.
-
Product
Microprocessorized Instrument
MP-100
-
Mobile meter designed to measuring the magnetic permeability lower as 3 and allows to control the elements with small overall dimensions and the elements with complex shapes as well as it allows the evaluations of heterogeneity of the elements with big overall dimensions. The meter contain the measurements memory and all obtained date could be display on LCD. The meter contain also RS232 interface which allow the data transmittion to PC.
-
Product
LXI 1GHz 75ohm 8x4 Matrix
60-732-004
Matrix Switch Module
The 60-732 is a family of integrated RF matrices suitable for use up to 1.5GHz. The construction of the 60-732 provides a cost effective alternative for RF switching based on microwave switching elements while maintaining a high level of matrix performance. The design is fully scalable, allowing a variety of matrix sizes to be offered in a single family.
-
Product
Neutron Activation Analysis
-
Neutron Activation Analysis (NAA) is one of the most sensitive analytical techniques used for multi-element analysis available today. The NAA procedure is capable of providing both quantitative and qualitative results for individual elements, with sensitivities that can be superior to those possible by any other analytical technique. Elemental Analysis Incorporated (EAI), as an innovator in the development and application of radio-nuclear chemistry analytical techniques, now offers its clients the ability to analyze some 75 individual elements (including certain organic elements) by NAA at trace and ultra-trace concentrations. Moreover, by developing scientific liaisons with selected nuclear reactor sites in North America, EAI is able to offer customers the expertise and capabilities of the premier scientists and research facilities available today. Combined with EAI’s tradition of excellence in customer service and technical assistance, EAI is uniquely positioned to assist clients with timely, cost-effective, and reliable trace element analysis for almost every conceivable field of industry or scientific research.
-
Product
SparkFun Air Quality Sensor
SGP40 (Qwiic)
-
The SparkFun SGP40 Air Quality Sensor provides a measurement of the quality of the air in your room or house. The SGP40 is based on Sensirion's CMOSens® technology and uses a metal oxide (MOx) sensor with a temperature controlled micro hotplate and provides a humidity-compensated volatile organic compound (VOC) based indoor air quality signal. Both the sensing element and VOC Algorithm feature an unmatched robustness against contaminating gases present in real world applications enabling a unique long term stability as well as low drift and device to device variation.
-
Product
AMR Linear Sensors
-
MultiDimension Technology Co.,Ltd.
AMR linear sensor utilizes two push-pull Wheatstone bridges each composed of four highly sensitive AMR sensor elements. These Wheatstone bridges effectively compensate the sensor’s temperature drift to achieve outstanding temperature stability with minimal noise.
-
Product
X-ray Fluorescence
-
XRF analysis – one of the best analytical techniques to perform elemental analysis in all kinds of samples, no matter if liquids, solids or loose powders must be analyzed.
-
Product
Intelligent Edge Orchestration
-
Also known as edge orchestration, intelligent edge, or cloud orchestration, the evolving service cluster represents the newest generation of intelligent network-management system (NMS) technologies and capabilities. The edge-orchestration concept, however, runs much broader and deeper than NMS or element management system (EMS), providing far more intelligent, evolved, and numerous capabilities than originally conceived early-on during the technology's development.
-
Product
Raman Systems
-
Raman spectroscopy is a element specific non-contact analysis technique. It is widely used for the classification and quantification of a variety of substances and materials. Meanwhile, this versatile and selective method has established itself as an essential standard method in the industrial environment, making various process analytical applications easily accessible.
-
Product
TXRF Spectrometers
-
Total reflection X-ray fluorescence spectrometry (TXRF) is a well-established method for trace element analysis on a variety of samples.
-
Product
Secure NFC
-
Mobile security is expanding from the largely deployed SIM technology to the growing NFC, embedded Secure Element (eSE) and embedded SIM (eSIM) technologies in smartphones, tablets, wearables, and laptops. ST provides an exhaustive offer of NFC and eSE/eSIM products to address secure mobile transaction applications such as secure connectivity, payment wireless charging and automotive: from the state-of-the-art ST21NFC to the ST54 integrating the widely deployed ST33.
-
Product
Transformer Winding Resistance Meters
RMO TD Series
-
The RMO-TD Series On-Load Tap & Winding Resistance Analyzer is designed for the measurement of winding resistance of inductive elements, and for tap changer analysis. The RMO-TD series is based on the latest technology, using the most advanced switching technology available today. The RMO-TD series is accurate (0.1%), powerful (up to 60 A) and lightweight. It generates true, ripple-free DC current with automatic metering control and a discharge circuit.
-
Product
Metal Glazed High Voltage Chip Resistors, Anti-Sulfuration
SMG Series
-
*Flameproof UL94VO molded package, resistance to sulfuration, heat and humidity.*Special design for automatic surface mounting.*Metal-glaze elements provide high stable performance against environmental conditions and overload.Excellent mechanical strength & electrical stability.*Reducing assembly costs.
-
Product
Polarization Maintaining Collimator
-
Zhongke Rayzer Optical Technology Co.,Ltd
The basic element for in-line PM fiber optics components, such as PM Isolator, PM FWDM, PM Filter Coupler and PM Circulator. It has high extinction ratio, low insertion and high return loss. The unique processing and high quality AR coating also enable this collimator tohandle high power.
-
Product
Class A Ovens
-
Gruenberg ovens can be designed as Class A ovens to conform to OSHA, NFPA 86A, Factory Mutual (FM) and Factory Insurance Association (FIA) requirements. Class A ovens are equipped with a high exhaust rate: because the heating elements are an ignition source so a high exhaust rate is needed to dilute the volatile vapors below the “lower explosive limits.” As a result, the heating elements’ kW must be sufficiently increased to compensate for the heat loss caused by the above-normal exhaust rate. In addition, for a Class A oven to be energy efficient, the additional kW required must be carefully calculated according to solvent load and operating temperature requirements.
