Product

Loudspeaker Cable Testers

EMO E450

-

EMO Systems Canford Audio PLC

EMO E450 - EMO Systems Canford Audio PLC

The EMO E450 cable tester will test for continuity, cross connection, and open circuit in cables fitted with NL8FC 8-pole and NL4FC 4-pole Speakon connectors, 3-pin XLR connectors, and 2 or 3 pole A-gauge jacks. EP retrofit kits are available to allow cables fitted with EP 4, 5, 6, or 8 pin connectors to be tested. The EP connectors fit in two pre-punched holes on the rear of the tester accessed by removing the blanking panel. The kit's flying leads plug directly into connectors mounted on the tester's PCB.

Product

Controller

Model 4110/4100

-

Aquatrak Corp

Model 4110/4100 - Aquatrak Corp

The Model 4110 Controller retrieves electricalsignals from the Model 3000 Transducer, interprets the information, and relaysthe data to the local data logger. The standard controller features threeAmphenol connectors that communicate with the transducer, receive supply+12V power and SDI communications to the data logger and communicate via RS-232Serial signal to a data logger.   * Connections to DCP and Transducer  * Easy to install and maintain  * Compatible with RS232 outputAlso available from the factory is the same Model 4110Controller with flying leads in place of the amphenol connectors standardbetween the Transducer and DSP.

Product

Controllers

onTAP’s THREE TAP CONNECT JTAG

-

Flynn Systems Corp.

onTAP’s THREE TAP CONNECT JTAG - Flynn Systems Corp.

Connect the TAP CONNECT JTAG Controller to your application with either the Xilinx ribbon cable, flying leads, or Altera style adaptors. The onTAP TAP CONNECT Controller automatically senses and adjusts to target I/O voltages and interfaces to devices operating at 1.8 to 5.0 VDC for the standard controller, or 0.99 to 3.6 VDC for the low voltage controller, using the VREF voltage from the target chain. If there is no VREF available, you can set the voltage for the target application from the TAP CONNECT Controller. This facilitates easy configuration to many different JTAG ports, which is helpful in design and manufacturing.

Product

Ethernet Flying Lead

-

Teledyne Marine ODI

Teledyne Marine ODI

​Qualified 100m Subsea Ethernet jumpers designed for data transmission and real-time situational awareness and monitoring. The typical Ethernet harness system consists of wet-mateable, Nautilus connectors, Nautilus penetrators, and pressure balanced, oil-filled (PBOF) hose conduits. Internally, the Ethernet signals are transmitted over custom Ethernet cabling sealed to seawater ingress by two independent barriers. Seven and 12-way configurations are available. Subsea connection of the harnesses may be accomplished by ROV, Diver-Mate or Stab-Plate applications. For Ethernet needs above 100 meters, see Extended Ethernet Flying Leads.

Product

The Mag Lead

136

-

Electronic Specialties Inc.

136 - Electronic Specialties Inc.

*Mag Lead features a magnetic disconnect near the test probe end. *Just disconnect the test probe and you can “stick” to any metallic ground or test point. *Quit fumbling with alligator clips that fall off - Mag Lead’s powerfull magnet will hold tight! *This is a time saving tool - if you don’t have to walk to your tool box to retrieve your alligator clips, even on just half the occasions, then you’ve saved time. *Very helpful for automotive reference points and troubleshooting. *Can eliminate the need to hold probes while checking or monitoring a signal. *Two high power, low resistance magnets hold the probe to the lead. *Fits almost all Digital Multimeters and can be used with hand-held scopes too. *Get the Mag Lead, it stays put and won’t fall off, like alligator clips do!

Product

Leading Edge Sensors

-

LaserGauge

LaserGauge

The LaserGauge® Leading Edge Profiling System consists of a handheld or benchtop sensor and the Leading Edge software application. Designed to scan both sides of the blade simultaneously, the sensor returns a complete profile around the radius of the blade, which allows accurate measurements of the thickness and the plotting of the blade profile for comparison to its engineering design.

Product

Test Leads

-

PMK Mess- und Kom­mu­nika­tion­stech­nik GmbH

PMK Mess- und Kom­mu­nika­tion­stech­nik GmbH

It is used to test and measure the current in a circuit. These are simple devices which are coated and colored to indicate positive and negative with the device connector on one end.

Product

Test Leads and Probes

-

Pomona Electronics

Pomona Electronics

Test leads and probes are an intergral part of a complete measurement system and extend the capabilities of your digital multimeter.

Product

Dual Lead Adapter

PK106-1

-

Teledyne LeCroy

PK106-1 - Teledyne LeCroy

Dual Lead Adapter - Probe Kit Accessory.

Product

Test Lead Holders

-

Pomona Electronics

Pomona Electronics

Test lead holders offer a great way to organize and store your test leads. With the various types of cable and test leads available, Pomona offers many options to organize your test leads.

Product

Thermocouple Extension Lead

EXT-10

-

Physitemp Instruments

EXT-10 - Physitemp Instruments

The EXT-10 - 10 foot, Type T Thermocouple Extension Lead. Flexible vinyl covered.

Product

Flying Probe Programming & Test Development

-

Testing House, Inc.

Testing House, Inc.

Testing House offers full Flying Probe Programming and Test Development using its very own Seica Pilot LX Flying Probe Test Stations.

Product

Fuse Lead Automotive DMM Test Leads

134

-

Electronic Specialties Inc.

134 - Electronic Specialties Inc.

*ATC Fuse Holder In-Line *Provides extra overload protection *Can prevent your DMM’s internal fuse from blowing *For use with any Digital Multimeter

Product

Test Leads

8000 Series

-

Probe Master Inc.

8000 Series - Probe Master Inc.

The "SOFTIE" by Probe Master lets you say "goodbye" to hand fatigue and finger calluses. A soft probe that bends 90 degrees or more. A probe that conforms to the shape of your hand. This soft flexible probe bends gently to reduce wear and breakage of the lead. Many combinations are possible with the "screw on" accessories shown above. The 48" long, 18GA. test leads, are made of top quality silicone.

Product

Testing Leads Assortment (16PCS)

3605B

-

Peaceful Thriving Enterprise Co Ltd

3605B - Peaceful Thriving Enterprise Co Ltd

1. Suitable for use on the 6-24V circuits2. 4mm banana plugs connection3. Facilities the measurement on connectors and components without destroying the insulation or the plug connection.

Product

Flying Probe Tester

FA1811

-

HIOKI E.E. Corp

FA1811 - HIOKI E.E. Corp

Designed specifically for package board testing, the FA1811 achieves both high-precision contact with a total probing precision of 10 μm, and a testing speed rivaling generic flying probe testers to meet ever increasing demands for greater analytical power, faster testing speeds and reduced costs.