Crystal Oscillators
A crystal or piezoelectric element which resonates at a precise frequency made from quartz, rubidium or ceramics.
-
Product
Temperature Compensated Crystal Oscillators
-
Temperature Compensated Crystal Oscillators by Pasternack
-
Product
Temperature Compensated Crystal Oscillators
TCXOS & VCTCXOS
-
Temperature Compensated Crystal Oscillators (TCXO) deliver excellent temperature characteristics combined with low power consumption and fast warmup. Voltage Controlled Temperature Compensated Crystal Oscillators (VCTCXO) combine the same excellent temperature characteristics, low power consumption and fast warmup with a voltage control function to allow precise tuning of the output frequency after PCB assembly and later, to compensate for any effects of aging as well as offering the ability to pull back to nominal frequency where there is a change of circuit conditions
-
-
Product
Voltage Controlled Crystal Oscillators
VCXOS
-
Voltage Controlled Crystal Oscillators (VCXOs) are used for fine adjustment of the operating frequency and are normally used in conjunction with a phase locked loop.
-
Product
Quartz Crystall Oscillators
-
Superior crystal oscillator precision is required for both time and frequency in precision instrument applications such as synthesizers, counters and spectrum analyzers.
-
Product
Oven Controlled Crystal Oscillators
OCXOS
-
Oven Controlled Crystal Oscillators (OCXOs) deliver the ultimate piezo electric performance with stabilities down to less than ±1ppb. An OCXO offers frequency stabilities even tighter than those offered by a TCXO.
-
Product
Disciplined OCXOS
-
GPS Disciplined OCXOs (Oven Controlled Crystal Oscillators) are a range of advanced clock modules which provide electrical timing functionality for distributed network systems. These units primarily revolve around the 1PPS (pulse per second) timing synchronisation signal produced by a GPS frequency receiver which is derived from transmitted timing information received from GPS satellite systems.
-
Product
1HZ~100MHZ Crystal Oscillator Tester
CX-118A
-
Shenzhen Chuangxin Instruments Co., Ltd.
1 It's using reciprocal counting technique, high accuracy, wide measuring range, truly equal precision measurement, fast speed measurement, high sensitivity.2 single-chip microprocessor technology cycle frequency measurement and intelligent management, making the instrument has high reliability and excellent performance / price ratio.3 It's using LSI design, the use of CPLD devices, instrument components greatly reduced, reliability has been greatly improved, the average time between failures ≥10000h.The machine looks nice, small size, light weight, easy to use.
-
Product
Phase-Locked Crystal Oscillator
PLXO Series 0.9” x 0.9” x 0.25”
-
*Compact Surface Mount Package *Excellent Phase Noise and Stability *Configurable for any application
-
Product
voltage controlled crystal oscillator
VCXO
-
A VCXO (Voltage Controlled Crystal Oscillator) is a crystal oscillator the output frequency of which is controlled by adding an external control voltage via a frequency control input on a variable capacitance component such as a varactor diode connected in parallel to a load capacitance (CL). Epson VCXOs are divided into two types according to Voltage-Frequency (V-F) characteristic slopes depending on the AFC (Automatic Frequency Control) input configuration of the VCXO. One is a VCXO with a positive V-F slope and the other is a VCXO with a negative V-F slope. Please note that the input voltage of a control circuit will vary according to the individual type, as shown in Figs. 3 and 4. Epson's VCXOs are capable of either, depending on the customer's preference. Epson's VCXOs have been increasingly used for broader applications such as slave oscillators in phased-lock loops, or frequency modulators. Among the above types, a VCXO combined with a TCXO is called a VC-TCXO , respectively. These components have the merit of delicately controlling their output frequency electrically.
-
Product
Clock Oscillators
-
A crystal clock oscillator (sometimes referred to as a 'Standard Packaged Crystal Oscillator' or SPXO) is a 'plug and play' quartz crystal. It combines a quartz crystal resonator with an oscillator circuit in a single package to provide a fully functioning stand-alone oscillator circuit.
-
-
Product
Temperature compensated crystal oscillator
TCXO
-
A TCXO (Temperature compensated crystal oscillator) is a crystal oscillator with a temperature-sensitive reactance circuit in its oscillation loop to compensate the frequency-temperature characteristics inherent to the crystal unit. Epson's are classified into two types. One is a Direct-Type TCXOwith a temperature compensation circuit built into the oscillation loop. The other is an Indirect-Type TCXO with a temperature compensation circuit outside the oscillation loop, in which the oscillation frequency is therefore indirectly controlled.
-
Product
Quartz Crystal Microbalance
-
Determining moisture concentration in natural gas, industrial gases or process gas is critical to many applications. QCM and electrolytic analyzers deliver fast, reliable and cost-effective measurements that support these processes.
-
-
Product
Quartz Crystal Microbalance
QCM200
-
Stanford Research Systems, Inc.
The QCM200 Quartz Crystal Microbalance measures mass and viscosity in processes occurring at or near surfaces, or within thin films. This system includes a controller, crystal oscillator electronics, crystal holder, three quartz crystals, and Windows / Mac software.
-
Product
Rubidium Oscillator
-
Rubidium oscillators are a type of atomic clock and are the most accurate time standards known and are used as time distribution services to control things such as telecommunications infrastructure, TV broadcasts and global navigation satellite systems (GPS).
-
Product
Single Crystal Films
YIG
-
Due to their very low microwave losses, single crystal ferromagnetic materials such as Yttrium Iron Garnet (YIG) and doped YIG are used for devices in microwave technology.
-
Product
Oscillators
-
Dependent on the frequency range Kuhne electronic has Oscillator solutions available which are either working with PLL-Stabilization or which are Quartz based.
-
Product
Rubidium Oscillator
IQRB-2
-
The IQRB-2 low noise rubidium oscillator is a sub-miniature atomic oscillator combined with 'active noise filter' technology. This rubidium oscillator has 100 times less drift than OCXOs and with short term stability of 0.002ppb/s at 100s this rubidium oscillator provides significant improvements in performance over other rubidium components.
-
Product
Oscillators
VCXO
-
A crystal oscillator whose output frequency varies based on an applied control voltage.
-
Product
High-Speed Oscillators
-
Renesas' laser diode driver product portfolio includes a push-pull oscillator used to reduce laser noise.
-
Product
Rubidium Oscillators
-
Our range of precise low noise rubidium oscillators in a variety of sizes to suit all appliations. These acurate frequency references are used in telecoms, aviation, nautical and precision test and measurement enviroments.
-
Product
Oscillating Disc Rheometer
EKT-100H
-
Designed and manufactured in accordance with ASTM D2048& ISO 6502 standards. Output, displayed and memorized graphics including Elastic torque, Cure rate, and Upper/Lower dies temperatures. More than 30 items of data, such as ML, MH, TS, TC, CRI etc., couble be taken from each test. Cure curve provides the processing, vulcanizing, and vulcanized physical properties of rubber cross-linking reaction.
-
Product
Oscillators
-
Precision Test Systems is increasingly becoming a world leader in ultra low phase noise (ULN) crystal and rubidium oscillators. We also have recently launached a new range of low G sensitive oscillators. For more information on our Low G range.
-
Product
Voltage Controlled Oscillators
-
Teledyne RF & Microwave offers Voltage Controlled Oscillators (VCOs) utilizing bipolar transistors & silicon varactors over the frequency range of 40 MHz to 18GHz. Many of the VCO designs incorporate internal filtering, regulation & amplifiers to meet total system requirements in a small integrated package. Additionally, our hermetic hybrid designs can be screened to the most demanding military and space applications.
-
Product
Rubidium Oscillators
-
Our range of atomic / rubidium disciplined time and frequency standards in a variety of enclosures and sizes to suit all appliations. These acurate time and frequency references are used in telecoms, aviation, nautical and precision test and measurement enviroments.
-
Product
Legendary Calibration Oscillator
LCO Series 3.5” x 2.5” x 0.6”
-
*Connectorized Package *Low Output Power Variation (±0.05 dB)*Output Power to +10 dBm Available *Optional Internal Reference
-
Product
Voltage Controlled GUNN Oscillators
GV-8 / GV-6
-
Voltage controlled GUNN oscillators provide optimal electronic tuning by coupling GUNN with tuning varactor. Oscillators provide low AM and FM noise, making them suitable as local oscillators or transmitters.
-
Product
GPS Disciplined Oscillator
GDX Series 3.5” x 2.5” x 0.6”
-
*Connectorized Package *1 PPS Input from GPS Receiver *Up to Four Fixed-Frequency RF Outputs *Optional Loss of Lock Output *Optional Holdover Alarm Output *Low Phase Noise
