-
Product
Custom, 6-Slot, Front to Rear Cooling, AC Power Supercomputer Application
Barracuda 216 CS7520
-
Your product description goes here.
-
Product
Special Application Thermal & Pressure Mass Flow Controllers
-
Certain process vapors and gases require mass flow controllers of a special design specific to the material as well as process conditions. MKS offers both thermal mass flow controllers and pressure based mass flow controllers for these applications that require flow control at elevated temperatures and/or low pressure drop conditions given the source material characteristics.
-
Product
High-Speed MWIR Camera for Range & Science Applications
FLIR RS8500
-
The FLIR RS8500 MWIR infrared camera system is a high-performance thermal camera and infrared telescope combined in a single weatherproof housing, specifically designed for long-range tracking and measurement applications including military range, aerospace, and outdoor research. Built around a high-resolution 1280 × 1024 midwave indium antimonide detector with the ability to deliver data up to 180 frames per second, the RS8500 provides 24% more pixels and a 46% faster frame speed than the previous model. Multiple simultaneous data and video output options allow the camera to be easily integrated into most data acquisition systems.
-
Product
2.5 inch SATA SSD for Industrial Embedded Applications
2.5 inch SATA SSD Series
-
ADLINK’s industrial 2.5 inch SATA SSD Series delivers all the advantages of today’s flash disk technologies with SATA 6Gb/s interface, and is fully compliant with the standard 2.5" form factor, providing low power consumption and hot-swap capability. Capacities of up to 2TB are available and read/write speeds of up to 560MB/s and 500MB/s respectively are supported.
-
Product
Stackable And Configurable Signal Generator For CAN Applications.
K- Volt
-
The K-Volt can be used to generate fast configurable analog and digital signals from CAN messages. Designed for high speed and accurate simulation of sensors (For example HIL and Replay systems). The K-Volt can be connected directly to a PC via a USB connection.
-
Product
Pressure Transmitters For Industrial Applications
Series 21 Y
-
KELLER AG für Druckmesstechnik
The Y-line transmitters have an extremely small temperature error. This is achieved using an additional circuit containing a temperature sensor that subdivides the temperature range into fields that are 1,5 Kelvin (K) wide.
-
Product
Structural Testing Application Examples Using EDM Modal
-
Illustrated below are some customer applications in varying industries who are using the hardware and software by Crystal Instruments to analyze and understand the structural properties of their test specimen(s). Analyzing the modal characteristics namely natural frequencies, damping and mode shapes of the test unit further helps in improving the design to enhance the mechanical behavior of the test unit.
-
Product
IRIG 106 Chapter 10 SDK for MIL-STD-1553 Applications
Avionics Interface Technologies — A Teradyne Company LOGIN Open Search Form F-SIM-1553-AVOE F-SIM-1553-AVOE
-
Avionics Interface Technologies
Supports Capture, Recording, & Analysis of MIL-STD-1553 Chapter 10 Ethernet Data Streams - View Live MIL-STD-1553 Data and Activity Statistics from one or more Chapter 10 Streams - Compatible with AIT eDAQ-1553 & eDAQ-1553-FQ Modules - Open, View, Save, & Analyze MIL-STD-1553 bus data from Chapter 10 Archive Files - Replay MIL-STD-1553 bus data from Chapter 10 Archives using any of AIT’s MIL-STD-1553 Interface modules - Supported in AIT’s Flight Simulyzer simulation and analyzer software application
-
Product
COM Express Type 6 Application Board With LVDS, VGA, DDI, Dual LANs And Audio
CEB94021
-
*125 x 95 mini size form factor*2 GbE LANs*SATA-600*LVDS, VGA and DDI*4 USB 2.0 and 2 USB 3.0*2 PCI Express Mini Card slots*3 RS- 232/422/485 and 1 RS-232
-
Product
NFC and Mobile Payment Application Testing
-
An increasing number of banks and mobile operators are now offering mobile contactless payments to their customers. As with EMV contactless cards, the mobile payment application contained on the SIM needs to be certified by the contactless payment schemes, and in some cases by GlobalPlatform.
-
Product
Application Performance Management
-
Enterprise-class testing and monitoring platform for websites, applications and APIs. Internationally distributed load testing and monitoring agents can regularly and programmatically check your targeted websites. web applications, API services, authentication services, certificates, DNS services, and more for performance and service-level compliance.
-
Product
100GE Application & Security Test Load Module
CloudStorm
-
Keysight Network Applications and Security
Ixia's CloudStormTM is an industry-first 2.4 terabit application and security test solution that not only meets today’s need, but that of the future. CloudStorm delivers 3X-application and 4X-SSL-emulation scale over any other test system. It helps NEMs shortening their development cycles, and enterprises and data center operators find the right balance between mitigating security risks and delivering high end-user application performance. Emulate multi-terabit DDoS and botnet attacks to future-proof security solutions
-
Product
Cameras for Mobile Applications
-
- Programmable to IEC 61131-3 with CODESYS- Robust metal housing for surface or panel mounting- High-performance CAN interface for various communication tasks- E1 type approval (German Federal Motor Transport Authority)
-
Product
Application & Client Platforms
-
GENBAND has a rich tradition of developing innovative, feature-rich platforms that seamlessly integrate with standards-based endpoints and clients. By embracing the latest technologies, such as HTML5, REST APIs client containers and WebRTC, GENBAND solutions improve user choices and experiences, even as they lower deployment costs for service providers and enterprises. It’s no surprise that GENBAND platforms already support millions of residential and business users worldwide. Key platform elements include:
-
Product
Receiver Conformance Test Application for IEEE 802.3ck
M8091CKCA
-
Designed to assist and simplify the stress signal calibration used for testing the inputs of IEEE 802.3ck Draft 3.3 chip-to-chip (C2C) and chip-to-module (C2M) electrical interfaces using Keysight M8040A 64Gbaud Higher Performance BERT or an M8050A 120Gbd High-Performance BERT together with Keysight Digital Communication Analyzer (DCA) Oscilloscope or Infiniium UXR real-time Oscilloscope.
-
Product
MIL-STD-1553 IRIG 106 Chapter 10 Streaming Application
F-SIM-1553-CH10-STREAM
-
Avionics Interface Technologies
Streams MIL-STD-1553 Data from AIT MIL-STD-1553 interfaces in Chapter 10 Format - Software application which is Compatible with all AIT MIL-STD-1553 Interfaces - Capable of streaming data captured from one or multiple MIL-STD-1553 Bus Interfaces - Streamed data can be sent to a single network system or multicast on the Ethernet LAN - Compatible with AIT F-SIM-1553-AVOE analyzer or 3rd party Chapter 10 systems - Timestamps & Errors detected embedded in Chapter 10 stream
-
Product
1.8-148 MHz Stand Alone Weatherproof Unit for the Application of DC Control Signals up to 400ma on your Coax Cable
Bias-T PLUS
-
The Array Solutions Bias-T PLUS is a 1.8-148 MHz stand alone weatherproof unit that permits the application of DC control signals of up to 400ma on your coax cable. By inserting the control voltage on the coax cable feed-line, you eliminate the requirement for external DC wires for powering remote devices.The Bias-T PLUS weatherproof assembly means that it can be placed indoors or outdoors for maximum flexibility. Typically, one Bias-T PLUS will be placed indoors for inserting DC on your coax feed-line, and one Bias-T PLUS will be placed at the remote device where the DC voltage is extracted.
-
Product
Application Lifecycle Management
ALM
-
Manage and track the various stages of an application's life, including requirements gathering, design, development, testing, deployment, maintenance, and retirement.
-
Product
X-Series Measurement Applications for Signal/Spectrum Analyzers
-
The X-Series applications are proven, ready-to-use measurements for signal analysis. Simplifying complex tasks and delivering repeatable results, the applications let you see and understand the performance of your cellular, wireless and aerospace/defense devices and designs.
-
Product
Particulate Matter Web Data Logger
HD50PM
-
Newly added into the succesful HD50 series, the HD50PM has been developped to allow data logging of PM1.0, PM2.5, PM4.0, PM10 and typical particles size. More background information on why to measure Particulate Matter (PM) can be found here.
-
Product
Web DDOS Protection
-
DDoS attacks continue to increase and still cause great damage today. In addition to the frequency, the complexity and duration of an attack cause major problems for the defense. Therefore, the deployed solution should intervene precisely and quickly to best protect you from threats and high costs due to downtime.
-
Product
Precision Flying Probe Platforms For Automated Test Applications
-
Flying Probe technology is used to automate the testing of printed circuit boards (PCB) that would otherwise have to be tested manually. Adding a Huntron Access Prober to your test procedure will significantly decrease test times therefore increasing productivity.Access Probers can accurately place a probe on test points with high accuracy achieved using micro-stepping motors and linear laser encoders. Probing the smallest surface mounted devices is possible. Huntron Access Probers can automate your unique test process using the standard probe or by adding a custom probe of your design. Huntron offers three Flying Probe system configurations based on PCB size and test head requirements.
-
Product
Film Application & Test Charts
-
For numerous products, such as paint, ink, varnishes, glue and cosmetics, the reliability of many laboratory tests is directly related to the quality and consistency of the samples. Any measurements made on coatings for the purpose of describing their physical properties (drying time, elasticity, abrasion, gloss, colour, shade, etc.) are made on the basis of uniform and comparable samples with precisely controlled thickness.
-
Product
Electronic Tensile Strength Tester Pull Force Test Chamber Applicable Industri
-
Shenzhen Chuangxin Instruments Co., Ltd.
This machine can test various materials (both finished and semi-finished products ) of tensile strength ,compressive strength and elongation ,can do stripping ,tear strength ,flexural ,compression test and etc. It can connect up to the computer and display or printout the test times , test value , max. value , etc . Also it can make various report forms according to the requirements .
-
Product
Comprehensive Suite of Software Tools for Semiconductor Test Applications
ICEasy Test Suite
-
Marvin Test Solutions' ICEasy Test Suite is supplied with both the TS-900 and TS-960 semiconductor test platforms and provides a comprehensive set of software tools - facilitating the development and debugging of test programs for semiconductor devices. In addition the suite includes I-V curve and Shmoo plot tools for analyzing a device's DC and AC characteristics. The complete suite of tools interfaces seemlessly with Marvin Test Solutions' ATEasy®, a test executive and test development evironment which is supplied with each TS-900 / TS-960 system.
-
Product
Banking Application Testing Services
-
QACraft provides comprehensive testing services for Banking and Finance websites to improve overall performance and generate more revenue.
-
Product
Industrial CANopen And CANopen FD Module For Digital I/O Applications
PCAN-MicroMod FD DR CANopen Digital 1
-
The PCAN-MicroMod FD DR CANopen Digital 1 is an I/O module for use in CANopen and CANopen FD networks. The modern CANopen FD® standard makes it possible to cope with the constantly increasing need for data transmission from sensors, machines and complex production systems. The module has a CAN FD interface as well as 8 digital inputs and 8 digital outputs. With the DIN rail housing and the support of the extended temperature range, the module is suitable for use in an industrial environment.
-
Product
Application Specific LC Systems
Nexera-e
-
The comprehensive 2D-LC methodology is a paradigm shift in liquid chromatography separation analysis. By combining two independent separation modes orthogonally in combination with a dual-loop/dual-valve alternate switching design, the highest possible peak capacity is achieved for LC chromatography separation. The new Nexera-e enables separation of even the most complex mixtures, providing a new level of knowledge and understanding of sample analytes. This is especially beneficial to the analysis of pharmaceutical impurities, proteolytic digests, food extracts, natural products and synthetic polymers.
-
Product
Dedicated Chemistry Application & Instrumentation Software
chemvue
-
Chemvue is intuitively designed for chemistry investigations, programmed with input from faculty for college lab student success. It enables convenient data collection and analysis, elegant college lab report design, and easy export options. Coming soon to your local device.
-
Product
MIMIC® Web Simulator
-
MIMIC Web Simulator creates a virtual lab with hundreds of simulated web servers. It allows you to easily develop and test your web clients, management and monitoring products. Having a virtual and scalable environment, you can try variety of scenarios to test your applications to assure your customers that your web services will work properly when deployed across heterogeneous environments. Best of all, you can reduce your lab budget significantly.
