Receivers
Equipment that is the sink or terminator of any signal on a transmission medium. (atis.org)
See Also: ITA
-
product
Signal, Module, Receiver, TriPaddle, 90 Series, 64 Position, w/ Right Angle Contacts
510104187
Primary mating module 510108101. (May mate with other ITA modules, as well.)
-
product
Single Channel One Analyzer
MVNA-8-350-1
The upper half of the Central Unit is the Vector Receiver (VR) of the Analyzer, which can be a single channel one, model VR-8-350-1 (one millimeter wave signal detected at a time only)
-
product
Terrestrial Demodulator
DTTCaster
The DTTCaster is a multi-standard DTT professional demodulator that supports DVB-T, DVB-T2 and ISDB-T/Tb standards. In DVB-T and DVB-T2, it will output a MPEG-2-TS over ASI and IP. In ISDB-T/Tb, the DTTCaster is able to output a TS at 32.5 Mb/s over ASI and IP including all the services of the layers available off-air. At the same time, it can receive DVB-T, DVB-T2 and ISDB-T/Tb signals and output the MPEG-2 TS over the 4 available ASI ports and both IP data ports of the chassis..
-
product
MIPI D-PHY v2.1 Receiver Conformance Test Software
N5991MD2A
The Rx solution including Station Configurator and Valiframe maximizes the usage of test instruments, providing automated system calibration as well as conformance testing according to the D-PHY 2.1 test specification (CTS)
-
product
Phase ID Systems
LED Meter Probe allows the user to take Real time Phase Angle readings along with AC nominal voltage readings. A PD800W LED Meter Probe works in conjunction with the Receive Unit to verify phase identification along with the actual phase angle data. This is all done without any calculations or data transfer from the field to a base computer. The meter probe and reference probe or receive unit can operate at 100 feet of separation and up to 300 feet line of sight separation. In the event that this distance would need to be greater, the Receive Unit can be unplugged from the charging cable and taken into the field while operating on it's rechargeable batteries for up to 8 hours at a time.
-
product
IF Digital Processing Board for Demodulation and Combining
LS-35-R
The Lumistar LS-35-R is part of the Lumistar family of digital processing boards used for programmable telemetry systems. The LS-35-R consists of a digital processing main board with two high capacity Xilinx Virtex-5 arrays. The LS-35-R provides a two-channel IF Receiver with Pre/Post detect combining, multimode demodulators with data rates up to 40 Mbps, bit synchronizer outputs, Viterbi decoding, spectral and constellation display, BER reader display and 70 MHz IF modulator with calibratednoise feature. The all-digital design assures a consistent product with high reliability and long-term stability.
-
product
2x8 Coherent Mixer With Single-ended Photodetectors
This page defines the requirement of a special coherent receiver with 8 single-ended photodiode outputs, per customer request. The coherent mixer, consisting of two polarization-diversified 90deg optical hybrids, a polarizing beam splitter and a beam splitter, is exactly same as existing DP-QPSK coherent mixer, and therefore offering same optical performance.
-
product
Satellite Signal Level Meter
Jointron(Quanzhou)Industry Co.,Limited
We're one ORIGINAL professional manufacturer of satellite and Terrestrial TV equipments and accessories.Here we'd like to get in touch with importers, distributors, retailers throughout the world. Since 2003, we have been exporting all kinds of satellite receivers and terrestrial receivers, and we carry a wide-range of the following products:1.Satellite TV EquipmentsIncluding satellite receivers, satellite signal level meter, satellite finder(meter), HD DVB-S2 Receivers, DVB-S2 Meter with Spectrum Analzyer(in real time)2.Terrestrial TV EquipmentsInlcuding DVB-T receivers, DVB-T Meter, HD MPEG-4 DVB-T Meter, HD MPEG-4 DVB-T Receiver, SD MPEG-4 DVB-T Receiver3.Combo Equipment:Including SD MPEG-2 Satellite&Terrestrial Combo Meter, HD MPEG-4 satellite&Terrestrial Combo Meter
-
product
Small Form Factor Recorder
Talon RTR 255x series
The Talon RTR 255x series implements Pentek's extensive line of digital serial modules including 40Gb Ethernet, serial Front Panel Data Port (sFPDP) and LVDS. All are capable of both receiving and transmitting data for recording and playback of data streams. The digital serial interfaces provide popular options for remote connection of the recorder to data sources. RTR 2555 - Ethernet: 1-, 10-, and 40-Gigabit Ethernet supporting both TCP and UDP protocols, with copper or optical interfaces.
-
product
Fast Tuned Notch Filter
ES005 & ES006
Teledyne Defence & Space’s (TDS) range of Fast Tuned Notch Filters (FTNF) have been designed to protect Electronic Support Measures (ESM) receivers from high duty cycle, frequency agile interference produced by on board (or cohort) combat radar systems. ESM sensors often need protection from high power nearby radars, and such signals can reduce receiver dynamic range.
-
product
Digital Receiver XMC
XF07-518
Curtiss-Wright Defense Solutions
The XF07-518 is a rugged quad channel 500MSPS 14-bit digital receiver XMC. The ADC devices are controlled by a user programmable Xilinx FPGA which allows high performance processing such as Digital Down Conversion (DDC), filtering and custom algorithms.
-
product
FTTH Optical Node
SR2020AW
Hangzhou Softel Optic Co., Ltd.
SR2020AW, the operating bandwidth of 47~1000MHz, is a low power, high performance, cost-effective triple play, FTTH CATV optical receiver, Whether used in analog television or digital television. Products with high sensitivity optical receiver tube and special low noise matching circuit. Receiving at high optical power can be adjusted by PAD level, played limiting output, so SR2020AW within a large dynamic range of the received optical power of +2 dBm ~-21dBm, have excellent characteristics.
-
product
Cable Assembly, Receiver, QuadraPaddle, 20", 2 68-Pin Male VHDCI
540072010140
Cable Assembly, Receiver, QuadraPaddle, 20", 2 68-Pin Male VHDCI
-
product
Microwave Panoramic Receiver
MVNA-8-350-1-2
It is possible to attach a dual channel receiver VR-8-350-2, to a single-HM microwave part MP-8-350-1, creating in that way a very flexible measuring system, a "microwave panoramic receiver" with which one can extract two separate signals from the single detector HM (or extension ASA-2).
-
product
Protective Cover, G20x, Receiver, 6.75" Series Adapters
310113597
Protective Cover, G20x, Receiver, 6.75" Series Adapters
-
product
ARINC-429 Controller for PCI
PCI302
The PCI302 provides four ARINC-429 compatible channels (2x receive and 2x transmit) at any rate between 12.5 and 100kbps.Because the PCI302 is built upon a flexible platform, the user functions can be implemented almost without restriction, making this product flexible and user-friendly.
-
product
Cable Assembly, Receiver, TriPaddle & Mini Coax, 20", 9-Pin DIN, 3 BNC Plugs and SMB Plug
540037010111
Cable Assembly, Receiver, TriPaddle & Mini Coax, 20", 9-Pin DIN, 3 BNC Plugs and SMB Plug
-
product
Low Phase Noise Amplifiers
Low Phase Noise amplifiers are critical for many applications requiring high signal integrity. This is especially relevant in instrumentation, defense, and telecommunication applications where low phase noise amplifiers are becoming increasingly important as the oscillators improve. Phase noise is described as the close-in noise to the carrier that can often appear as jitter on a clock signal. Analog Devices offers a large portfolio of low phase noise amplifiers to meet a variety of requirements in the LO network, receiver, as well as in the transmitter. Our portfolio supports a wide range of power levels and frequencies to provide the right solution for the given application.
-
-
product
Low PIM Coaxial Switch, DC to 20 GHz, Matrix
87406Q
Low passive intermodulation (PIM) is crucial for applications where two or more transmitted signals share a common antenna or whenever the transmitter signal is too high or the receiver is sensitive to high intermodulation. The Keysight 87406Q is a low PIM matrix coaxial switch, operating from DC to 20 GHz, which can help to keep the system PIM level low. A guaranteed 0.03 dB insertion loss repeatability and 3 million cycles of operating life ensures signal integrity, improves testing efficiency and ultimately maximizes test throughput.
-
product
90deg Hybrid With Balanced Receiver
This page describes one of Optoplex's innovated products, a 90deg optical hybrid integrated with balanced photo-receivers, which can be used in optical sensing applications, particularly the coherent Doppler wind LIDAR (light detection and ranging). Coherent detection has been widely found in applications for RF and optical communications. In the past few years, coherent technology has been advanced dramatically in high-speed optical communications. With this advancement, key parts and components are commercially available and cost-effective for many applications beyond telecommunications, such as narrow linewidth lasers, optical hybrid, balanced photo-receivers, and DSP, etc.
-
product
SWR True Antenna Analyzer
SWR True Antenna Analyzer is a versatile analyzer covering all major communication bands from 30MHz to 2700MHz. The SWR True will analyze antennas and cables. Measurements are represented graphically as VSWR or Return Loss plots. The built in PLL synthesized generator offers a superior accuracy with small step size. The internal operating system controls measurement, display and the I/Os allowing serial communication to PC, USB to memory stick and USB Serial communication. The I/O options are used to write plots to either memory sticks or to a connected PC, the I/Os can also be used to operate the instrument, giving commands and receiving data. For documentation reference the instrument has a real time clock. Multilayer menus are used to setup and control the operation of parameters. The SWR True instrument is small, handy and light weight battery operated with more than 6 hours of continuous operation on the internal NiMh cells. Feature with XML data handling and application viewer is included. Accessory kit with soft carrying bag, car charger and coax adapters for standard types.
-
product
Cable Assembly, Receiver, TriPaddle, 36", 200 Pin Male LFH w/ M3 Jackscrews
540105010205
Cable Assembly, Receiver, TriPaddle, 36", 200 Pin Male LFH w/ M3 Jackscrews
-
product
1211a Optical Receiver/Distribution
Precise Time and Frequency, Inc.
To complement the range of high quality frequency and timing references, Precise Time and Frequency, LLC. has now introduced a new Optical Time Code Receiver, with Auto Switching, a full complement of time code outputs, and Ethernet/RS232 remote monitoring/control interface.In addition to the auto switching capability, the new ptf 1211A delivers up to thirty six channels of Time Code outputs, including re-transmission of the optical input. The unit can accept a pair of inputs (usually from separate primary and backup sources), and provides monitoring of both the inputs and outputs for signal integrity.If the primary input fails, the unit will automatically switch to the backup input and indicate a primary signal fault.Full remote monitoring and control via RS232 and Ethernet interfaces includes telnet, http (web browser), and SNMP protocols.
-
product
Vacuum, Module, Receiver, 90 Series, 2 Port Positions
510104260
Primary mating module 510108242. (May mate with other ITA modules, as well.)
-
product
Mounting Panel, iCon, 6U, 6 Positions, with Slide Mounting (slide kit required)
310113635
The 6U Slide-Mounted Plate mounts to standard 19" racks and slides open to allow access to wiring between the instruments and VPC iCon receivers. The 6 cutouts are space evenly across the panel. iCon cover plate is sold separately (310113467). This mounting plate is designed to work with a slide kit and includes flanges and an instrument bracket. A slide kit is required for use.
-
product
Signal, Module, Receiver, TriPaddle, 64 Position, w/ Right Angle Contacts
510104109
Primary mating module 510108101. (May mate with other ITA modules, as well.)
-
product
Coax, Patchcord, Receiver, 72", Mini Coax, RG178 Tan, Single Ended
7-334178000-072
Coax, Patchcord, Receiver, 72", Mini Coax, RG178 Tan, Single Ended.
-
product
Cable Assembly, Receiver, 20", TriPaddle, 15 Pin FML DSub, 9 Pin FML DSub
540214010101
Cable Assembly, Receiver, 20", TriPaddle, 15 Pin FML DSub, 9 Pin FML DSub.
-
product
Digital Display for the Transducers and Transmitters
PS57
The PS57 is a combination power supply and 4 1/2 digit LED display for the P55/P855 family of pressure transducers and transmitters. The PS57 accepts 110 VAC power and provides the required 24 Vdc excitation for the transducer. The transducer signal is received and displayed directly in engineering units with bright 0.56 high red LEDs. The user can re-scale the display and set the decimal point by configuring internal jumpers. The analog output of the transducer, 5 Vdc or 4-20 mA, is available on rear-panel terminals.
