Fiber Optic Spectrometers
-
Product
MIL-STD-1553 Fiber Optic Bus Extender
FO-1553
-
Avionics Interface Technologies
Extends MIL-STD-1553 bus access to over 1 mile for remote access - Dual redundant, single and dual stream options available - Both Transformer and Direct coupling modes supported - Uses fiber optic 1.0625 Gbps data rates for low latency over long distances - Optical signaling is not affected by electrical noise and interference - Simple and easy to use solution, no software setup or configuration required - Ideal for applications where test equipment is separated from UUT
-
Product
- RS-422 to Fiber Optic Converter
Model 272A
-
FEATURES: Data Rate to 2.5 MBPS; Full Duplex TD and RD; ST Connectors; Extends RS-422 Network up to 2 km (6,600 ft). The Model 272A provides the capability of performing an interface conversion between full duplex, RS-422 signals and their equivalent for fiber optic transmission.
-
Product
Spectrometer
AirSPEC
-
Baltic Scientific Instruments, Ltd
Scintillation gamma-ray spectrometer AirSPEC is intended for measuring scintillation spectra and alsofor determination of activities and specific activities of radionuclides in samples and in conditions of natural occurrence in geometries 2 and 4.Spectrometercan be usedfor various tasksradiation monitoring, including the definition ofspecific effective activity of naturally occurring radionuclides (NORM) in building materials (granite,crushed stone, gravel, etc.), raw materials, products, waste industrial productionand rockswithoutsampling; measurements surface activity of the radionuclide 137Cs (and other); mass fraction of NORM in rocks andoresin the conditions oftheirnatural occurrence on a surface, inboreholes and in warehouses andtransportcontainers, and also in study ofsurface contaminationof soil,as well asprospecting and exploration ofmineral deposits resources.The spectrometercan be used forworkin the laboratoryand in the field conditions.
-
Product
Fiber Optic Test Kits & Sets
-
Amphenol Fiber Systems International
Amphenol Fiber Systems International (AFSI) has selected test equipment that is ideal for the field technicians who install and test our products. We offer a wide range of test equipment that meets our customers needs, including the periodic installer to the rugged field requirements for the US Army and USMC deployed or depot maintenance personnel to the advanced requirements of the Navy Shipboard installer requiring Navy approved test sets.
-
Product
Fiber Optic Connectors & Cages
-
Pulse Electronics Networking BU supplies high-quality fiber optic connectors and cages to innovative ODMs, OEMs and other manufacturers designing today’s most demanding network products. Our line of 40+ fiber optic connectors include SFP, SFP+, and QSFP connector and cage products.
-
Product
Fiber Optic Visual Fault Finder
VFF5
-
Used to verify continuity, test and find breaks in fibre links, locate pinched fibre strands in termination cabinets, or anywhere fibre optic cables are terminated and subject to mechanical damage.
-
Product
TXRF Spectrometers
-
Total reflection X-ray fluorescence spectrometry (TXRF) is a well-established method for trace element analysis on a variety of samples.
-
Product
Spectrometers
Maya 2000
-
Maya2000 Pro Spectrometers offer high sensitivity in configurations that cover a range of ~165-1100 nm. They are perfect for deep-UV (vacuum UV), UV-Vis and Vis-NIR measurements.
-
Product
Fiber Optic Connectors
-
TE's fiber optic connectors accommodate 10G Ethernet — with the capacity to handle next-generation 40G and 100G when needed — without the severe distance limitations of copper cable. Easy to maintain in the field, and reliable when operating in harsh environments, our fiber optic cable connectors offer significant size and weight savings. Our broad portfolio includes several fiber optic connector types including standard fiber connectors, LC connectors and SC connectors.
-
Product
Spectrometers
-
Since spectroscopy is used for numerous applications, we have defined our products in different lines, as seen below. We offer instruments with a small form factor to integrate into other devices in the CompactLine: high-sensitivity instruments for more demanding applications in the SensLine and spectrometers especially configured for the near-infrared range in our NIRLine. The StarLine spectrometers are our most versatile instruments for general spectroscopy applications.
-
Product
Optical Fiber Identifier
-
OrienTek Optical Technology Ltd.
Optocal Fiber Identifier Economical Solution for Integrated Fiber Preparation Tool Demand● 4 easy-change chucks for:bare fiber, patch cords & ribbon fiber● Identifies 3 common test tones● Identifies dominant traffic direction, audible alarm● Approximate core power reading● Low false detection & insertion loss● Very easy to operate● Battery low indication
-
Product
Omnisens Optical Fiber And Cable Measurement And Quality Control
https://www.omnisens.com/uploads/1/2/0/5/120592129/telecom-1_orig.png
-
To provide quality control or help with the design and testing of fibers, Omnisens Vision offers fast, accurate strain and temperature measurements.Omnisens Vision is based on Brillouin scattering. In single mode fibers it produces precision readings with high spatial resolution over long distances and/or large loss test conditions. It is capable of high speed testing in dynamic situations such as flex fatigue.Its configuration flexibility makes the Omnisens Vision well adapted to a wide variety of test & measurement needs.
-
Product
Ultrafast Fiber Optic Photodetectors
DXM Series
-
The DXM series of Ultrafast Detectors are fiber-coupled photodetectors with wide wavelength ranges, as shown in the plot to the right, that are designed to be used for a variety applications. Each provides a high-fidelity electrical output pulse in response to an optical input pulse, and their clean impulse responses have full width half maxima (FWHM) down to 15 ps.
-
Product
RS-232 Fiber Optic Auto Powered Line Driver
Model 271
-
FEATURES: Full Duplex to 56 KBPS; 2 Kilometers on 62/125 Fiber; Total Electrical Isolation; Eliminates Noise Problems; ST Connectors; No Power Required. The Model 271 provides feature packed performance and reliability for data transmission over glass fiber.
-
Product
Optical Fiber 1×25 Switch
OFSW - 1 × 25
-
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 1×25 is a 1×25 prism optical switch. It can support 1 optical fibers input and 25 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
Product
Fiber Optic Transceivers
-
Shanghai Tarluz Telecom Tech Co., LTD
Also known as Optical Transceiver or Optical Module. It is a small packaged device that uses fiber optic technology to transmit and receive data.
-
Product
High Power Fiber Optic Visual Fault Locator
VFL-700
-
Shanghai Fibretool Technology Co.,Ltd.
The VFL-700 is specially designed for field personnel who need an efficient and economical tool for fiber tracing, fiber routing and continuity checking in an optical network during and after installation.
-
Product
Optical Fiber Identifier
X5004
-
Lower power indicationEasy-to-replace adaptersEasy-to-use with "ONE KEY" operationDisplays the relative core powerDurable metal housing and quality constructionEfficiently identifies the fiber transmission direction and frequency tone (270Hz, 1 KHz, 2 KHz) with audible warning
-
Product
Fiber optic thermometer systems
TS Series
-
Micronor now offers a complete range of fiber optic temperature sensors, probes and interfaces for temperature measurement in challenging environments. TS series fiber optic temperature probes offer immunity to RF and microwave radiation along with wide temperature range, intrinsic safety and non-invasive use. The fiber optic temperature probes can operate over -200°C to +300°C (-328°F to +572°C), and withstand harsh and corrosive environments. Typical fiber optic temperature monitoring applications include:
-
Product
Fiber Optic Multiplexer
FAC1000/2000
-
The FAC 1000/2000 is a multiplexer oriented to multi-point communication with several devices using fiber optic. It provides one or two inputs and multiple outputs.
-
Product
Polymer Optical Fiber (POF) Contacts
-
VPC offers Polymer Optical Fiber (POF) contacts in the form of patchcords. POF supports low-speed, short distance applications.
-
Product
1310nm Direct Modulated Fiber Optical Transmitter
ONT-8600AS
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai 1310nm direct modulation fiber optical transmitter, adopts high linearity DFB laser of famous brand in the world, and builds-in perfect pre-distortion adjustment circuit and laser APC, ATC closed loop control circuit. All the operating parameters of fiber optical transmitter are controlled by microprocessor, and the LCD screen on the front panel can display relative operating status and the fault information.
-
Product
SFP Based Fiber Optic Test Solution
Eye-BERT Micro
-
The Eye-BERT Micro is a low cost, easy to use, all-in-one SFP based fiber optic test solution offering high performance bit error rate testing at a fraction of the cost while providing a rich set of features not found in other bit error rate testers. Features include: variable bit rate, user programmable patterns, and optical power and temperature monitoring (per SFP capability). Additionally, with a click of a button, the Eye-BERT Micro will automatically test an SFP module based on the information it reads from the module and generate a detailed test report complete with manufacturer, part number, serial number, date code, fiber type, link length, speed, and test results. The Unit is supplied with anti-skid bumpers and is small enough to be integrated into larger systems for dedicated link verification.
-
Product
FTIR Spectrometers
-
Fourier Transform Infrared (FTIR) spectroscopy is a non-destructive analytical technique that can be applied to solid, liquid, and gas samples. Measuring the mid-IR spectral range, from 4,000 cm-1 to 400 cm-1, the technique detects vibrational transitions of molecules, therefore an FTIR spectrum contains vibrational information on the sample studied.
-
Product
Fiber Optic Components For Optoelectronic Packaging
-
OZ Optics offers a wide range of standard and custom fiber optic components for optoelectronic packaging. Components include collimators, focusers, patchcords, connectors, and metalized fiber. The low backreflection collimators and focusers are available for a wide range of industry-standard connectors and wavelengths. The hermetically sealable patchcords, with glass or metal solder, and metalized fiber meet high Telcordia standards. The polarization maintaining patchcords and connectors use our specially designed ferrules that minimize insertion loss, backlash, and rotational errors.
-
Product
Fiber Optic Sensors
-
Achieve highly reliable and precise fiber optic sensing. Advanced Energy’s Luxtron® patented FluorOptic® temperature measurement solutions and WaveCaptureTM Fiber Bragg Grating (FBG) sensing solutions feature many options to meet your application needs.
-
Product
Fiber Optical Monitoring Alarm System
FOMA
-
FOMA (Fiber Optical Monitoring Alarm System) is integrated RTU (Remote Test Unit) 、Center Monitoring Server and its management software to achieve integrated operation、remote management、unattended monitor、periodic fiber scan、predictive analysis and support the instant fiber with status information and alarm warning, accurate of long-term fiber data record.
-
Product
Plastical Optical Fiber
POF
-
POF (Plastic Optical Fiber) is a new, convenient, effective, and economical method to construct optical networks at small office or home. A visible red light of 650 nm is utilized in this application so users can easily see the light at the cutting edge of the POF. Major application here is 100Mbps Fast Ethernet over POF implemented by distinct media converter or switches.
-
Product
HPGe Detectors & Spectrometers
-
Baltic Scientific Instruments, Ltd
Baltic Scientific Instruments produces Gamma- and X-ray spectrometers based on HPGe coaxial or planar detectors with liquid nitrogen and electric machine cooling. The spectrometers are used for the radionuclide analysis and calculation of the activity in nuclear industry and environment monitoring, as well as in various spheres of industry, science and technology.
-
Product
Miniature Spectrometer
MSP1000
-
The MSP1000 miniature spectrometer (MiniSpec) is a compact, fibre-coupled spectrometer suitable for common laboratory tasks. By using the latest manufacturing techniques, we are now able to provide the system for a cost of less than £1000.
