Product

Wire Strippers

-

Omega Engineering, Inc

Omega Engineering, Inc

Thermocouple wire, cable and OMEGACLAD™ wire at strippers. Specialized wire and cables require specialized tools. Make your choice with a range of diameters and gauges.

Product

Wire Piercing Clips

619

-

Electronic Specialties Inc.

619 - Electronic Specialties Inc.

This new clip makes wire piercing much easier. Just slide the wire into the cradle and screw the pin down into the wire. This method is clean and leaves minimal wire damage. If you have to proceed to pierce the wire, do it the right way with 619.

Product

Mating Coax Connector And 20 Coax Pins Crimped (One End) To 3 Foot Wires

GX96404

-

Marvin Test Solutions, Inc.

GX96404 - Marvin Test Solutions, Inc.

Mating Coax Connector and 20 Coax Pins Crimped (One End) to 3 Foot Wires

Product

Wire Rope Detector

-

Testech Group Co., Ltd

Testech Group Co., Ltd

It adopts the method of magnetic flux leakage and magnetic flux, and uses the Ethernet high-speed transmission method, which can accurately complete the non-destructive testing of the wire rope in service.

Product

Gauge Type T Thermocouple Wire

W-TW-44

-

Physitemp Instruments

W-TW-44 - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Drawing Die And Wire Measurement

DGMS – Die Geometry Measuring System

-

Optik Elektronik Gerätetechnik GmbH

DGMS – Die Geometry Measuring System - Optik Elektronik Gerätetechnik GmbH

Measuring system for diameter, roundness, reduction angle and bearing length of wire drawing dies.

Product

Handheld Wiring Analyzer

HT-128+

-

NEXU Technologies, Inc.

HT-128+ - NEXU Technologies, Inc.

Reduce your wire harness assembly and installation difficulties now. The NEXU HT-128+ test platform provides a valuable tool for multi-point wiring continuity analysis. Our versatile, lightweight, handheld unit can serve your wiring test and maintenance needs from harness layout to product field support. The HT-128+ performs testing and troubleshooting, automated ring-out, directed assembly plus other features to resolve wiring issues quickly to achieve increased product availability!

Product

One Wire Communication Board

MS 1727

-

Meltronics Systemtech

MS 1727 - Meltronics Systemtech

- Digital serial bus communication with low speed data over a single line, Both signaling and driving power over a same single signal.- Protocol used in small inexpensive devices. Such as digital thermometer, weather instruments, laptop sub module, authenticate system and some cell phone battery packs.- Always master only initiates the communication and in overall in charge of the network.- Bus communicates with master and slave at a low data rate of 12kbps.- All terminals in the network are communicating by half-duplex mode.- Maximum of 255 nodes in each 1-wire network- Each data transaction will start with 480micro second low RESET pulse.

Product

Cables, Harnesses & Wiring Looms

-

AmFax Ltd

AmFax Ltd

​Amfax manufacture a wide range of wiring harness solutions in a variety of styles and finishes. These wiring harnesses, or looms as they are often called, can be constructed using heat-shrink, conduit tube, braid, tape, tie-wraps or lacing cord.

Product

Sun Trackers

STR-series

-

EKO Instruments Co., Ltd.

STR-series - EKO Instruments Co., Ltd.

EKO Sun Trackers are very compact, robust, relatively light weight and very power efficient. Inside the Sun Tracker a Harmonic Drive with advanced motion control unit is used on each output shaft. Harmonic drive is a leading drive technology for those application where high precision, durability, low backlash, high transmission ratios and torque is required. Due to its compact design and high transmission ratio small motors could be used to keep the power consumption low.

Product

Pitch Tracker

-

Daqarta

Daqarta

The above image shows the Daqarta Pitch Track Toolbox feature as it tracks a whistled version of "Deck The Halls". The approximate locations of the corresponding words are shown at the bottom of the Notes Edit area below the trace.

Product

Drawing Die And Wire Measurement

Drawing Die Inspector DDI

-

Optik Elektronik Gerätetechnik GmbH

Drawing Die Inspector DDI - Optik Elektronik Gerätetechnik GmbH

Special microscope setup for visual inspection of wire drawing dies.

Product

Lo-PRO®file Collet Socket with Wire Wrap Pins

Series 503

-

Aries

Series 503 - Aries

LO-PRO file Collet Sockets with Wire Wrap Pins. Features: LO-PRO file Collet Sockets are available with solder tail or wire wrap pins. Consult Data Sheet No. 12011 for solder tail pins. Choose from several sizes and plating options.

Product

1 Ft Harness, 78-Pin Male Connector On One End, Loose Wired (Numbered) Other End

GT97103

-

Marvin Test Solutions, Inc.

GT97103 - Marvin Test Solutions, Inc.

1' harness, 78-pin male D-sub connector on one end, loose wired (numbered) other end.

Product

Vibrating Wire Peripherals

-

Campbell Scientific, Inc.

Campbell Scientific, Inc.

Many Campbell Scientific vibrating-wire peripherals enable dataloggers to read vibrating-wire sensors (also known as vibrating-wire or vibrating-strip transducers). These sensors measure strain, load, pressure, and water level, and they output a frequency signal generated by a vibrating filament. Campbell Scientific also offers vibrating-wire dataloggers that read the sensors directly.

Product

Wired Serial Device Server

SD-300

-

Silex Technology

SD-300 - Silex Technology

The Silex SD-300 and SD-310AN are designed to easily connect and share RS-232 serial devices over a wired or wireless network. Industrial automation, building automation, medical devices, security access and control, point of sale devices, LED signs, bar code/label and other specialty printers, or virtually any other device with a serial port can be now be enabled with secure, robust wired or wireless network capability.

Product

Wire Damaged Tester

WDT-1

-

Lisun Electronics Inc.

WDT-1 - Lisun Electronics Inc.

This equipment is designed and manufactured according to corresponding regulation in standard IEC884-1, GB299.1-96, GB16915.1-97 and other electronic accessories relevant standard. Mainly used to test damage degree of fixed connection components lead wire of with thread clamping type and no screw terminals, so as to inspect whether it can withstand mechanical stress during normal use.Specification: • Power supply: AC220V 50Hz • Test rate: 10±2r/min (GB16915.1-97: 12 ±1r/min) • Rotating radius: 100mm • Test distance: 250~500mm adjustable • Test numbers (Number of rotating): 0~999999 any set • Mass: 0.3KG, 0.4KG, 0.7KG, 0.9KG, 1.4KG, and 2.0KG (GB16915.1-97: 30N, 40N, 50N, 60N each of 2 pcs) • Stations: 2 • Dimension: 1200×1400×400 (mm) • Remarks: The mass and rotating radius can be optional as per customer requirements.