Product

Transformer Winding Resistance Testers / TRT ? 2

TRT-2

-

UDEYRAJ ELECTRICALS PRIVATE LIMITED

TRT-2 - UDEYRAJ ELECTRICALS PRIVATE LIMITED

Fast measurement: Test current 0.02A to 2A DC, Digital display of resistance and test current.

Product

Loop Resistance Measuring Device According to DIN EN 61557-3 (VDE 0413-3)

-

PeakTech Prüf- und Messtechnik GmbH

PeakTech Prüf- und Messtechnik GmbH

A loop tester which is used to test the safety of electrical systems. These device measures the impedance of the short-circuit loop between the outer conductors of a circuit, whereby the probable short-circuit current is calculated. The protection of the circuit (miniature circuit breaker) must therefore trigger at a lower current than the expected short-circuit current, in order to avoid excessive heating of the lines and thus a fire risk. The PeakTech 2715 is due to its function and its robust design almost indispensable when performing new installations, but also for general checking of electrical systems, this device is the ideal companion.

Product

Programmable AC/DC Hipot & Insulation Resistance Tester

-

Shenzhen Chuangxin Instruments Co., Ltd.

Shenzhen Chuangxin Instruments Co., Ltd.

Programmable AC/DC Hipot & Insulation Resistance Tester can do hipot test and insulation resistance test.

Product

Resistance Meter

MT8-4L

-

Holding Informtest

MT8-4L - Holding Informtest

М-module МТ8-4Л is a mezzanine module designed to measure the resistance of resistive sensors using a four-wire measurement circuit in eight channels (eight-channel digitizer). М-module МТ8-4Л is installed on the carrier of mezzanines - module НМ-М and is connected to it via a local information highway. Up to four m-modules of various types can be installed on the NM-M module. The NM-M module, together with the m-modules installed on it, forms a VXI module of size C-1 and is used to create information measuring VXI systems.

Product

DIP Header with Coined Contacts

Series 600

-

Aries

Series 600 - Aries

DIP Headers with Coined Contacts. Aries offers a full line of DIP headers, available with either coined or screw machine contacts. Consult Data Sheet No. 12035 for screw machine contacts. Snap-on, protective covers are available for all sizes shown below and accommodate .125 [3.18] to .750 [9.05] component heights. Consult Data Sheet No. 12033 for protective covers.

Product

Winding Resistance Meter 15Amps, 2 Channels

WR14

-

Raytech AG

WR14 - Raytech AG

Raytech's Digital Winding Resistance meter WR14 is the battery powered version winding resistance system with a most advanced demagnetizing circuit. It is designed for high degree of accuracy measurement of very low resistance of any inductive loads.

Product

Meters for Contact Angle and Surface Tension

SURFTENS UNIVERSAL

-

Optik Elektronik Gerätetechnik GmbH

SURFTENS UNIVERSAL - Optik Elektronik Gerätetechnik GmbH

Robust measuring device for contact angle, SFE and surface tension with numerous equipment variants such as motorized dosing systems, multiple dosing systems and tilting device.

Product

Resistance Welding

-

Nippon Avionics Co.,Ltd.

Nippon Avionics Co.,Ltd.

Resistance welding is a method in which the welding works are heated by resistance heat generated by sandwiching the welding workpieces with welding electrodes, passing current through them, and the metal is welded while pressurizing the works.A resistance welding machine composed of welding power supply, a weld head and an electrode. The welding power supply controls a welding current,the weld head exerts a pressure on the material to weld and the electrode provides welding current and pressurization force to the part under welding. We have been providing various kinds of welding power supplies and welding heads to meet these requirements.

Product

Multiple High Resistance Standard

MHS

-

Ohm-Labs, Inc.

MHS - Ohm-Labs, Inc.

*1 MEGOHM TO 1 TERAOHM*FULLY GUARDED*HIGH IMMUNITY FROM AMBIENT TEMPERATURE CHANGES*TRANSPORTABLEOhm-Labs' new Multiple High Resistance Standard maintains state-of-the-art resistance at levels above 1 megohm.

Product

PE-, Insulation Resistance, HV- and Function Tester

GLP1-g

-

Schleich Gmbh

GLP1-g - Schleich Gmbh

GLP1-g testers are ideally suited for use in production, laboratory, test field, quality management, automation and many more applications. Thanks to the individual combination of functions you are able to reach your aims quickly, reliably and cost-effectively.

Product

200V 20 Ohm Portable Battery Resistance Voltage Tester

TOB-SM8124

-

Xiamen Tob New Energy Technology Co., Ltd

TOB-SM8124 - Xiamen Tob New Energy Technology Co., Ltd

200V 20 Ohm Portable Battery Tester For Battery Voltage and Resistance Testing. TOB-SM8124 Resistance Voltage Tester is a portable battery tester used for battery voltage and internal resistance test, it is Suitable for lithium-ion battery, nickel-metal hydride, lithium manganese, lead-acid battery and other single battery or battery pack with voltage no more than 200V.

Product

Resistivity Meters

-

Botron Inc.

Botron Inc.

Periodic compliance checks of ESD work surfaces are super important. Monitors only verify the ground plane, or path to ground. The surface itself can wear down, become dirty, or if you use low quality mat—just not hold up. A handheld Surface Meter is great for running monthly, or prescriptive compliance verification of your ESD surfaces.

Product

Advanced Powder Resistance Kit

PRK-130

-

Prostat Corporation

PRK-130 - Prostat Corporation

The PRK-130 is an advanced kit that includes the PRF-930 Powder Resistance Fixture for measuring the bulk resistance of powder and granulated materials. Test material is placed in the cavity between the measurement plates. Once a measurement has been made in ohms, a fixture calculation, or correction factor, converts the resistance measurement to volume resistivity in ohm-cm.

Product

Din Abrasion Resistance Tester

SG-P01D

-

Jinge Testing Machine Co.,Ltd

SG-P01D - Jinge Testing Machine Co.,Ltd

This tester is used to determine the abrasion characters of elastomers, rubber, soft synthetics, leather. etc or is with characters of high efficiency, good reproducibility and easy operation.

Product

Sole Puncture Resistant Tester

UI-FT03-1

-

Unuo Instruments

UI-FT03-1 - Unuo Instruments

Sole Puncture Resistant Tester is to test safety shoe sole steel plate insert nail puncture resistance/penetration ability.

Product

Earthing Resistance Tester

JYD-10A

-

Kingrun Instrument Co., Ltd.

JYD-10A - Kingrun Instrument Co., Ltd.

transformer neutral grounding resistor is the vital need in medium voltage AC distribution network that are also called by different names like Neutral Earthling Resistors. They are taken into use to limit the current that would flow through the neutral point of a transformer or generator in the event of an earth fault. They are also used for resistance grounding of connected generators and transformers.

Product

Insulation Resistance Measuring Equipment

AMIC-5010

-

Amperis sl

AMIC-5010 - Amperis sl

Insulation resistance measurement - 15TΩ: * 50 - 1000 V, in 10 V steps, * 1000 - 5000 V, in 25 V steps ; Memory of 999 results and transmission to PC ; Measurement of AC and DC voltage and capacity ; Measurement of leakage current and function with digital filter ; Measurement of continuity of protection and equipotential connections ; Adjustable alarm limits

Product

Fiber Optic Contacts

-

Virginia Panel Corporation

Virginia Panel Corporation

VPC offers Multimode and POF patchcords designed to meet a variety of fiber optic cabling needs.

Product

Step & Contact Meter

HT2055

-

HT Italia Srl

HT2055 - HT Italia Srl

HT2055 consists in a power unit and a voltmetric unit, necessary for carrying out step and contact voltage measurements in industrial electric installations (TN systems, transformer cabinets) with a rated test current up to 50A.

Product

Mask ventilation resistance and pressure differential tester

WKS-3102

-

Lisun Electronics Inc.

WKS-3102 - Lisun Electronics Inc.

Mask ventilation resistance and pressure differential tester is used to measure the inhalation and exhalation resistance of mask under specified conditions. Applicable to mask manufacturers, labor protection equipment inspection agencies to carry out related testing and inspection of mask products, mask breath resistance tester, breathing valve air tightness tester, breath resistance machine for measuring respirator and mask protection products in Inspiratory resistance and expiratory resistance under specified conditions.

Product

Electronic Resistance Store

MEMS5

-

Holding Informtest

MEMS5 - Holding Informtest

Mezzanine MEMS5 is designed to reproduce the values ​​of resistance to direct current through five channels independent and galvanically isolated from each other and from the case.

Product

3 Wire (Analogue) Earth Resistance Tester

ST-1505

-

Standard Electric Works Co., Ltd

ST-1505 - Standard Electric Works Co., Ltd

● High quality Taut Band movement.● Capable of measuring earth resistance and earth voltage.● The timer operates automatically for about three to five minutes when the “PUSH BUTTON SWITCH” and “TIMER ON BUTTON” are pressed together. ● This will keep test “ON” for the duration of the timer.● Battery check function.● Calibration performed with supplied test leads.

Product

Ground Resistance Clamp Meter

61-920

-

IDEAL Industries, Inc.

61-920 - IDEAL Industries, Inc.

*Auto ranging*Auto power off*Hard case included*2-year warranty

Product

10KV High Voltage Digital Insulation Resistance Tester

KM 6213AIN

-

Kusam Electrical Industries Limited

KM 6213AIN - Kusam Electrical Industries Limited

• The KM 6213A IN is the KUSAM-MECO premium model of High Voltage Digital Insulation Resistance Testers.• The KM 6213A IN has new added features with a low consumption High Performance processor.• It displays results much faster and has more advanced features.• The KM 6213A IN has Automatic Polarization Index and Dielectric Absorption Ratio Calculations.• Results are displayed on the new High Contrast LCD. It’s mounting angle makes it more readable for all users, in different working conditions.• The user’s manual reflects the new features and added benefits of this instrument.• It has Auto-Off, Auto-Stop, EnerSave™ and is a non destructive tester.• Once you start the tester, it waits for your selection. You can go up and down in voltage to select the voltage at which you want to test the insulation. Once you have selected that voltage, you need to connect the test leads to the Insulation Tester to measure. Then it measures voltage to ensure there is no voltage present on the equipment under test. If there is a voltage present, it will warn you to disconnect the circuit before proceeding. If it’s free of any voltage, then you can proceed with the testing. This ensures that no damage is done to the Insulation Tester KM 6213AIN.• One of the new innovation on this tester is also the way the new unique calibration process works. It’s fully digital, has no moving parts and does not require expensive and complicated jigs or computers systems to be calibrated. It’s cheaper to maintain than any other Digital HV Insulation tester on the market today. The KM 6213AIN is supplied standard with our Premium test Leads Kit, the AL-50.

Product

Electronic Store Of Resistances

PS8

-

Holding Informtest

PS8 - Holding Informtest

The module is intended for use as part of information measuring systems based on the VXI bus for software setting of resistance values ​​with a given step along three independent channels.