Biconic Antennas
attenna conductors are flared into two cones diametrically opposed, sharing a common axis and vertex.
-
product
Small Cell/ Outdoor DAS Antennas
*Omni, Quasi-omni, Trisector, Cardioid and Bi-sector formats*Pole mounted and Stadium style antenna configuration*High band, low band and dual band models available*Integrates GPS antenna available on select models
-
product
Probe Antennas
Probe antennas are offered as both standard and custom models with a rectangular waveguide interface. Probe antennas can only support linear polarization. These antennas are often used to measure the gain of other antennas by comparing the signal levels of the probe antenna and antenna under testing. The standard models operate across the full waveguide band and offer 6.5 dB nominal gain and 115 and 60 degrees half power beamwidth at center frequency. The below standard offering covers the frequency range of 8.2 to 170 GHz.
-
product
Single-Wavelength Fused Bi-conical Taper 1×N splitter (FBT Splitter)
PON-POS-1
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai single-wavelength Fused Bi-conical Taper (FBT) 1×N star optical fiber splitter is the series connection of N-1 pieces of 1×2 splitter. The bandwidth of +/-40nm under 1310nm, 1490nm or 1550nm makes the splitter meet the requirement of ratio accuracy. And it has feature of low additional loss and low polarization sensibility loss.
-
product
Bi-Sector Array Antennas
*Dual 33 degree beam antennas with a 65 degree pattern foot print*Multi-band capable*IIndependent tilt control for each beam**RemoteElectricalTilt (AISG 2.0)*Increase site capacity & data throughput
-
product
Antenna Noise Canceller
ANC-4
The ANC-4 is an rf device that eliminates or reduces power line noise, BPL noise, computer noise, TV-generated interference, and other types of electrical noise. The ANC-4 unit connects right to the antenna connector of the receiver or transceiver to cancel locally generated noise before it gets into the receiver and affects the receiver AGC circuits.
-
product
Direction Finding Spinning And Bifilar Helical Antennas
Kratos Defense & Security Solutions, Inc.
Kratos’ Direction Finding (DF) spinning antenna system is designed for mobile, marine, and airborne applications. DF antennas are capable of measuring the direction from which a received signal was transmitted. Kratos’ Bifilar Helical antenna has been engineered for rapid assembly and survival in winds up to 115 mph. Bifilar Helical antennas are widely used for satellite communications.
-
product
Board-to-FPC Connector for 5G Millimeter-Wave Antenna Modules
Panasonic Industrial Devices Sales Company of America
Panasonic's Board-To-FPC Connector for 5G Millimeter-Wave Antenna Modules offer good SI/EMI/EMS characteristics for high-frequency applications and features our industry-leading Tough Contact construction that achieves high contact reliability and retention force. Tough against shock impact by misalignment, the fully-shielded structure in both socket and header significantly improves EMI characteristics necessary for RF applications such as 5G.
-
product
1310nm/1550nm Fused Biconical Taper WDM
SWD1315
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai SWD1315 single mode DWDM adopt fused bi-conical taper technical with low insertion loss, channel flatness features. Mainly used in optical network 1310nm and 1550nm combination and halve.
-
product
Antenna and Cable analyzers
VNA
Are used to analyze and fine-tune antennas and cables, measure cable parameters, and find cable faults.
-
product
Dipole Antennas
A6434
CAES manufactures dipole antennas for a variety of terrestrial applications including fixed-site, man-portable, and vehicular.
-
product
GPS / GNSS Antenna Signal Splitters
INSTOCK Wireless Components, Inc
INSTOCK Wireless GPS Signal Splitters are available in 2-way thru 48-way configurations spanning 1-2 GHz with unpeered performance in GPS (L1-L5), GNSS, Galileo, GLONASS, BeiDou, and IRNSS antenna splitting applications. The 200 ohm internal load on the DC-blocked port(s) prevents receivers from incorrectly sensing an antenna fault when there is no current draw. Type N, SMA, TNC, BNC, and QMA connector configurations INSTOCK.
-
product
MW AM Broadcast Mobile Antenna System
TUP-3
The TUP-3 system is capable of transmitting efficiently at carrier frequencies from below 1000 kHz to over 1700 kHz. It is rated for power to 5000 watts, 125 percent modulated. Housed is a weatherproof cabinet, the integral tuning unit features high quality electronic components and matches the TUP-3 system to a 50 ohm transmission line. The self-supporting design of the tower also minimizes erection time and complexity.
-
product
4 Antenna Phase Controller
StackMaster
This controller comes in two versions and is configurable to support all of the Array Solutions products. The version with the 11 output relays is meant to be used with the StackMaster and is described below.
-
product
Antenna, Wideband Discone
EM-6115 | 10 KHz – 2 GHz
The EM-6115 is a broad band collinear array allowing very wide Omni-Directional frequency coverage in a single package. Below approximately 100 MHz, the EM-6115 acts as an active vertical rod which offers 10 to 12 dB Greater unsaturated instantaneous dynamic range than competitive antennas (overload field strength: 2 V/meter) which greatly reduces intermodulation generated signals in a typical read world RF environment. In the congested spectrum above 100 MHz the antenna is passive and contributes no intermodulation products so the overload point is determined solely by the receiving instrument. This immunity to overload can often make the difference between useful signal output and an indecipherable jumble of spurious products and is accomplished without compromising sensitivity. The antenna collapses for convenient storage and transport.
-
product
Standard Gain Horn Antenna
KSHA-BJ260-25-2.92L
Standard Gain Horn Antenna, Frequency21.7~33GHz, Gain 25dBi, Linear Polarization, 2.92-Female
-
product
Antenna Tuner
DU-1500L
Model DU 1500 L is high power antenna tuner that uses and adjustable reactive network for matching the unbalanced 50 ohm output impedance of transmitters and transceivers to a variety of balanced and unbalanced loads.It is usable over a frequency range of 1.8-30 MHz. Provision is made for selecting one of three antennas or for bypassing the matching network.A crossed needles SWR and wattmeter with switchable 200 and 2000 watt scales and selectable peak and average power output reading is included.
-
product
Active Loop Antenna
AL-130R
Also known as Magnetic Loop Antenna, the AL-130R is compliant with CISPR 16-1-4. It is ideal for emissions measurements as required by various EMC standards such as FCC 18, CISPR 11, CISPR 13, CISPR 14, CISPR 32 and many more. The built-in, low-noise preamplifier, increases overall measurement sensitivity as well as the overall signal to noise ratio. As per ANSI C63.4-2014, the use of active loop antenna for compliance testing is permitted in a non-sheilded environment ONLY if the saturation indicator is continuously monitored during the course of testing. Com-Power’s Remote Antenna Interface (RAI-100) comes in very handy for this application. It is a compact controller which can be used to enable/ disable RF measurement circuit and monitor saturation and battery low conditions remotely via a fiber optic cable up to 30 mtrs in length.
-
product
VHF Antennas
From small craft to large ships, Shakespeare® VHF antennas are the go-to antennas to keep you connected utilizing the essential VHF marine radio.
-
product
Base Station Antennas
Fiberglass Collinear 118-960 MHz Omni Patterns - 500 Watts Standard connector is a recessed N-Female. 7-6 DIN available
-
-
product
Antenna, Log Periodic
EM-6954 | 70 MHz – 1 GHz
The EM-6954 is designed to meet antenna requirements for both field strength measurement and radiated susceptibility in the 70 MHz to 1 GHz frequency range.
-
product
Scalar Feed Horn Antennas
Scalar feed horns are offered as both standard and custom build models with either a circular or rectangular waveguide interface. While scalar feed horns with a rectangular waveguide interface can only support linear polarization, models with a circular waveguide interface can support various polarization types including horizontal, vertical, left-handed circular, and right-handed circular polarization for broader applications. The standard models operate across the full waveguide band and offer 17 dBi nominal gain, 25 degrees half power beamwidth and a -28 dB side lobe level at center frequency. The below standard offering covers the frequency range of 8.5 to 140 GHz. However, other frequencies or gain values are also available.
-
product
Antenna Sharing Combiners
*Combines two base stations to a common antenna and preserves receive diversity*Dual technology units in low band, high band, including AWS*Adjustable gain up to 10 dB*AISG 2.0 compliant
-
product
Antennas
Introducing the new RFSPACE Ultra-Wideband (UWB) and log periodic antennas. These antennas cover different frequency bands from 200 - 12000 MHz. Each antenna is hand tuned and tested to cover the specified frequency band continuously. All antennas except the UWB-4 and TSA900 come with a birth certificate showing the return loss plot of the antenna. The lower cost antennas are not plotted to keep price low.
-
product
Vehicle Antennas
Our portfolio of vehicle antennas includes single and multi-port options in ground plane dependent or ground plane independent formats. Our wide range of mounting options and accessories provides customers a choice of direct/thru-mount, magnetic mount, or covert in-vehicle antennas. Custom antenna developments are regularly undertaken to meet specific customer requirements. Our vehicle antenna portfolio includes products manufactured by TE Connectivity, Laird Connectivity External Antennas, and Hirschmann Car Communications
-
-
product
Monopole Antennas
COM201B
CAES offers monopole antennas for terrestrial applications such as fixed-site, man-portable and vehicular. CAES Monopole Antennas are designed to provide highly efficient, wideband coverage with radiation patterns that are omnidirectional in the azimuth plane, allowing a 360° field of view.
-
product
GNSS Smart Antenna
iCON gps 70 series
For construction professionals, Leica Geosystems introduces the most efficient GNSS rovers, the Leica iCON gps 70 Series. With the iCON gps 70 T you can measure and stakeout points quicker than ever before without the need to keep the pole vertical and level the bubble. The combination of the latest GNSS technology and inertial measurement unit (IMU) equips the iCON gps 70 T with permanent tilt compensation and makes it resistant to any magnetic interference. Being fully calibration-free, the iCON gps 70 T is ready when you are – anytime, anywhere.
-
product
Antenna Tuner HF+6m
DU 800 T
The DU 800 T optimizes the performance of your antenna and transmitter or SWL receiver by providing adjustable impedance matching. The DU 800 T also measures the Power and Standing Wave Ratio (SWR), which allows you to tune the indiceted SWR to the lowestpossible ratio for the selected transmit frequency.
-
product
Digital Antenna Monitors
1900 Series
There are three different units in the 1900 Series. The basic unit is the Model 1901.This 5 1/4 inch unit contains control/measurement circuitry for up to 12 towers, digital display of all measurements, local operating controls, and an interface to a remote control system. The control/measurement circuitry for each tower is contained in a separate module. The modules plug into the rearof the unit, and may be easily added to an expanding station.
