Partial Discharge Detection
indicate that localized dielectric breakdown within insulation has occured.
See Also: Partial Discharge, Partial Discharge Monitors, PD, PD Test, Partial Discharge Test, Partial Discharge Detectors
-
Product
Pinhole Detection Devices
-
ElektroPhysik Dr. Steingroever GmbH & Co. KG
The coating control by means of pore testing makes use of electrical voltage in order to uncover microscopically small defects (> 20 μm) in the coating of a surface. If even a small defect can be detected during pore testing of surface coatings, urgent action is required. Minimal flaws in the coating are sufficient to cause great damage.
-
Product
Wet Sponge Pinhole Detection
-
Wet Sponge Technique: A low voltage is applied to a moist sponge. When the sponge moves over a coating flaw, liquid penetrates to the substrate and completes an electrical circuit, setting off the alarm. The wet sponge technique is suitable for measuring insulating coatings less than 500μm (20mils) on conductive substrates, and is ideal for powder coatings and other coatings where the user does not wish to damage the coating.
-
Product
Switched Limiting Amplifier With Detected Output
-
Limiting amplifier sets dynamic range from -10.0 to -5.0 dBm input to 2.0 dBm output. TTL controlled, fast switching and high isolation 10 dB On-to-Off, and includes internal filtering for improved harmonic performance. Analog detector monitored output, or dual RF outputs.
-
Product
IQ4 Vertical Fall Metal Detection
-
The IQ4 Vertical Fall is a gravity fed / throat metal detector system designed for inspecting bulk, powders and granules. This system is supplied complete with frame, throughput tube and a choice of sealed valve or cowbell reject, depending on application.
-
Product
Contamination Detection and Analysis
-
Contamination testing, detection, analysis, troubleshooting and resolution expertise to minimise downtime, maintain customer confidence, for quality & safety
-
Product
Battery Discharge Capacity Tester
-
KV Hipot Power Test Equipment Co.,Ltd
Battery Discharge Capacity Tester is used to perform discharge testing which is the verifiable method to determine actual capacity of battery systems.
-
Product
Battery Discharger & Capacity Tester
IDCE-8X0
-
Fuzhou Fuguang Electronics Co., Ltd.
Wide Range: IDCE-8X0CT series can cover 10V~480V for multiple batteries test requirements like telecom (48VDC), powerutilities (110VDC, 220VDC), UPSs (300-60 VDC), traction batteries(12-96VDC)etc.
-
Product
Gas Detection System
TOC-625 MICRO
-
International Gas Detectors Ltd
For small systems up to 8 devices with simple I/O requirements this system is ideal. The TOC-625 Micro Gas Detection System Controller interfaces with existing TOC-30A addressable gas detectors and has auto detect and set up features making deployment fast and easy for installers not used to gas detection systems.
-
Product
Trace Detection
-
Rapiscan® Systems provides versatile, lightweight, easy to use, real-time trace detection solutions for mobile and permanent security screening operations.
-
Product
FM/ATEX Approved Static Discharge Cable Reels
Cen-Stat Static Discharge Reels
-
Retracting cable reels are an alternative solution to using retractable Cen-StatTM spiral cable. They are normally specified for locations where there is a preference for ensuring process operators stow grounding clamps correctly for good "housekeeping" purposes when the clamps are not in use.
-
Product
Oil Spill Detection
-
Combining proven capability in early detection with the presentation of essential spill information regarding oil spill volume estimates, deformation and drift, sigma S6 Oil Spill Detection significantly improves response time and mitigates potential environmental impact. sigma S6 Oil Spill Detection has been extensively tested and proven effective in independent trials conducted by the Norwegian Clean Seas Association for Operating Companies (NOFO).
-
Product
Utility Service And Leak Detection
-
Accurately preparing the site to make sure you know where all the utility services run can pay handsomely by avoiding those expensive digger accidents.
-
Product
Electrostatic Discharge Test
-
The electrostatic discharge test is designed to determine the ability of equipment to perform its intended function without permanent degradation of performance as a result of an air discharged electrostatic pulse. Electrostatic discharge is the result of an unbalanced electrical charge. Typically, it is created by insulator surfaces rubbing together or pulling apart. A transfer of electrostatic charge between bodies (materials, components, etc.) at different electrostatic potentials is caused by direct contact.
-
Product
Gas Detection System Controller
SMC Sentry IT
-
The SMC Sentry IT Controller is a powerful network-enabled hazardous gas detection system that operates up to 32 detectors and interfaces with devices over Modbus RTU, 4-20 mA, Sentry PSG Bus, and conventional dry contact. The embedded web application enables users to view important data remotely and provides connectivity into the Industrial Internet of Things (IIoT).
-
Product
Partial Discharge Test
INDIPORT
-
For medium voltage switchgear - partial discharge test in a few minutes - without shutdown.
-
Product
DDR Detective Logic Analyzer
DDR4
-
NOW supports 3DS at 3200MT/s!Provides logic analyzer like deep transaction Listing and Waveform capture. Continuous Capture for Violations and Performance metrics NOT a fill memory and then post process like other tools. This is a FuturePlus ONLY feature!
-
Product
Gunshot Detection & Localization System
-
Information System Technologies Inc.
ISTI’s acoustic transient (e.g. gunshot or any other) event detection and localization technologies exploit low-cost distributed sensors with local processing capabilities. Key benefits include: better capture of muzzle blast and ballistic shockwave in urban environments, lower false alarm, real-time response, robustness to loss of sensor nodes, low hardware complexity, flexibility to configure a dynamic local network and ease in deployment. The Graphical User Interface (GUI) allows for control over the sensors and network while providing an overall assessment picture. Unlike existing gunshot detection and gunshot localization systems, the distributed sensing solutions (algorithms and hardware/software) developed by ISTI can support different sensors including acoustic, seismic and IR.
-
Product
LPG Mass Flow Rate Detection System
-
This is a massflow rate measurement system that can measure the massflow rate of LPG with high accuracy using the Coriolis method massflow meter.LPG is a fuel that easily vaporizes, and it is not difficult to measure the correct flow rate in a gas-liquid mixed state.
-
Product
Leak Detection
-
Compressed air is a costly form of energy and 20 to 40% of it is lost through leaks.
-
Product
Glass Break Detection Sensor
ENVIROMUX-GBS
-
Acoustically detects the cracking of glass. Adjustable sensitivity. Includes mounting hardware. Connect to RJ45 or digital input sensor ports. Supports CAT5/5e/6 UTP or STP cables. Screw terminal. To connect to the RJ45 inputs use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor screw terminal. Maximum cable length: 1,000 ft (305 m). Powered by ENVIROMUX-2D/5D/16D.
-
Product
CBRNE Detection
-
Investments in intellectual horsepower, research and development; enable Bruker to offer a wide range of products with a broad technological base and high end instrumentation that includes:
-
Product
SF6 Gas Detection Thermographic Camera
TC706
-
The TC706 displays and signals SF6 gas leaks, without the need to de-energize high-voltage equipment or stop operation. The portable camera also highly improves operator safety by detecting emissions at safe distances and helping to protect the environment by detecting the leakage of environmentally harmful gases into the atmosphere.
-
Product
Reference Detect Switch
RDS Series 0.9” x 0.9" x 0.21”
-
*Surface Mount Package *Standard Internal TCXO (±2.5 ppm, Stability) *Tighter Stability Available *Fixed Frequencies to 100 MHz
-
Product
Neutronic Detection
-
Neutron imaging is a non-destructive method used to see inside objects that may be inpenetrable by X-ray or other techniques.Neutrons offer the benefit of being able to see through heavy metals such as lead but can also be used to examine delicate processes.Photonis Neutron detector is designed to provide either still images or video using both cold and thermal neutron imaging techniquesfor non-destructive testing and neutron tomography.
-
Product
IQ4 Waferthin Metal Detection
-
The IQ4 Waferthin is a compact gravity fed / throat metal detector system designed to be installed between gravity feed hoppers, multi-head weighers and VFFS bagging machines with a minimal metal free zone required.
-
Product
Ambient Light Sensors & Proximity Detection
-
ams supplies a family of products which combine an Ambient Light Sensor (ALS) and proximity detection in a single device. The ALS provides measurements of ambient light intensity which match the human eye’s response to light under a variety of lighting conditions, and through a variety of attenuation materials. The proximity detection feature allows a large dynamic range of operation for use over short distances and behind dark glass. These devices are intended for use in mobile phones, and over longer distances for presence detection in computer displays and monitors.
-
Product
Vacuum & Leak Detection Software
-
Agilent vacuum and leak detection software and app provide the data management performance needed to meet manufacturing yields, quality-control standards, and compliance requirements in industrial vacuum applications.The powerful Vacuum Link app offers wireless remote pump control, making it easy to monitor your system.A-PLUS software enables the user to control and monitor vacuum solutions.Leak Test Data Wizard software enables powerful tracking and automation of leak detection processes.
-
Product
Battery Discharge and Capacity Testers
-
HD Power Test Equipment Co.ltd
HDFD Battery Discharge Tester can be used as the discharge load in the battery off-line state to realize the constant discharge at the set value by regulating continuously the discharge current. When discharging, the tester will automatically stop discharging when the voltage on the battery group terminal or the cell falls to the set lower limit value, or when the set discharging time is out, or when it reaches the set discharging capacity. Battery Discharge Tester can records all valuable and continuous real-time data during the discharge process.This tester system is simple, safe and accurate for monitoring voltage of cells adopting wireless connection.
-
Product
Dirty Bomb Detection Jamming System
-
Security Intelligence Technologies, Inc.
The SSR-7000 consists of a radiation detection system that operates in concert with a MM Wave body scanner and an electronic countermeasure IED Defeat System. This three part solution is geared to deal with finding remote controlled weapons that are designed to detonate radioactive contents with a discharge that may or may not reach nuclear yield. Dirty bombs of this type are designed to cause terror and maximum panic.
-
Product
Intermittent Fault Detection & Isolation System
IFDIS
-
The IFDIS™ uses patented Intermittent Fault Detector technology that simultaneously and continuously monitors every circuit path within a Unit Under Test (UUT) - such as a Line Replaceable Unit (LRU) chassis' interconnects - for intermittent continuity failures that occur for as short as 50 nanoseconds. This state of the art technology is combined with an environmental chamber and vibration table, which simulate the UUT’s operational environment and cause intermittent faults to manifest, creating a system that is unsurpassed in intermittent fault detection.
