-
Product
10 MHz to 18 GHz Frequency Converter
8852
-
The 8852 Frequency Converter is designed to expand the VM-7 frequency range beyond 30MHz. The 8852 converts frequencies between 10MHz and 18GHz to the 30MHz signal required by the VM-7 while maintaining the power level of the original signal. The 8852 can also provide a 2GHz to 18GHz signal to drive the Frequency Converter Model 8853 for measurements above 18GHz.
-
Unlisted Product
Attenuator & Signal Calibrator (30MHz Receiver)
VM-7
-
The TEGAM Model VM-7 is a 30MHz receiver that performs precise measurement of RF power ratios over a wide dynamic range. It offers averaging, high resolution, and offset features to improve measurements and speed accessible through front panel keystrokes, or remotely through a GPIB controller.
-
Product
Dual Type IV Power Meter
1806
-
Designed for use with bolometer elements to measure high frequency or microwave power from 10W to 30 mW. Model 1806 also functions as a standard for the calibration of bolometers mounts, detectors, RF voltmeters, and for precision insertion loss measurements when used with the TEGAM System IIA, automatic power meter calibration system.
-
Product
High Power RF Calibration System
HPC
-
The TEGAM High Power Calibration System is the complete automated solution for calibrating through path and terminating RF power measurement devices from multiple manufacturers. It includes the signal generation, amplification and filtering necessary to achieve or exceed the devices original specifications with the most accurate High power measurement system available. Calibrate High Power RF Sensing devices up to 250 W with uncertainty less than 1%.
-
Product
Low Cost RF Power Sensor Calibrator (10 MHz to 18 GHz)
1825
-
Calibrates 10 MHz to 18 GHz RF power sensors in 30 minutes or less; Thermistor RF Power Standard is internally temperature controlled; Type IV Bridge Circuitry; DC Power Levels can be measured to within ±0.003%.
-
Product
Low Cost RF Power Sensor Calibrator (100 kHz to 18 GHz)
1827
-
Calibrates 100 kHz to 18 GHz RF power sensors in 30 minutes or less; two Switchable RF inputs; Thermistor RF Power Standard is internally temperature controlled; Type IV Bridge Circuitry; DC Power Levels can be measured to within 0.003%.
-
Product
RF Thermistor Power Meter
1830A
-
Thermistor based RF power sensors are universally recognized as the most accurate means to measure and transfer RF power. Compatible with thermistor power sensors from: Agilent (HP), TEGAM, Weinschel, Hughes, General Microwave, Millitech. Supports 100 and 200 thermistors. Integrates bridge balancer and power meter into one package. Four digit calibration factor resolution. Full remote programmability. Heater control for ovenized sensors. LXI Compliant.






