Solder Paste Measurement
assures volume and area of paste application.
See Also: Solder Paste, Solder Paste Inspection
-
Product
Coating Thickness Measurement
-
The Calotest instruments from Anton Paar provide quick, simple and inexpensive determination of coating thicknesses. Employing the simple ball-cratering method, the thickness of any kind of single or multi-layered coating stack is accurately checked in a short time, in full compliance with relevant international standards.
-
Product
Handheld Instruments for Measuring Humidity & Temperature
-
Our range of handheld instruments are perfect for monitoring environmental conditions. Models with an interchangeable probe input have the wide measurement ranges -100…200 °C, 0…100 %rh with a Rotronic probe selected for the application.
-
Product
Insulation Resistance Measuring Equipment
AMIC-5010
-
Insulation resistance measurement - 15TΩ: * 50 - 1000 V, in 10 V steps, * 1000 - 5000 V, in 25 V steps ; Memory of 999 results and transmission to PC ; Measurement of AC and DC voltage and capacity ; Measurement of leakage current and function with digital filter ; Measurement of continuity of protection and equipotential connections ; Adjustable alarm limits
-
Product
Automated Pit Identification and Measurement Software
APIMS
-
Surface pitting processes are ubiquitous in material science and engineering applications. Rigorous analysis of surface pitting features is time-consuming and error-prone whenever manual measurements are employed. Barron Associates’ APIMS software eliminates the need for tedious manual pit measurements. APIMS analyzes digital surface profilometry data and automatically identifies the location and size (width and depth) of surface pits. APIMS provides built-in noise reduction features to enhance performance and reduce both measurement noise and surface tilt.
-
Product
3D Roughness Measurement System
IF-Profiler
-
The If-Profiler is a handheld 3D roughness measurement system for high resolution measurement of surface finish. You measure roughness of flat and curved components with only one system. Measurements are performed both profile based (ISO 4287) and areal based (ISO 25178). The measurement system achieves flexible measurements and applications at high measurement speed. Various positions and measurement fields are traceably and intuitively measured. The IF-Profiler is also used to measure geometries with steep flanks and various coatings.
-
Product
Viscosity & Flow Measurement
-
Viscosity is perceived as ‘thickness’ or resistance to pouring, but there is more to viscosity than this. All fluids have an internal friction between molecules, which determines how well fluid flows. Due to this internal friction, energy is required to move the liquid and viscosity is the measure of the resistance to flow. Elcometer manufactures and supplies a wide range of viscosity gauges from flow cups to dip cups to rotational viscometers.
-
Product
Measurement Sensors
-
measurement sensors convert a physical phenomenon (such as sound or temperature) into a measurable analog voltage or digital signal. This signal is then further processed and converted into a legible display.
-
Product
Sound Intensity Measurement
-
Sound Intensity MeasurementA perfect tool for sound intensity level measurement and noise source determination brought to an entirely new level by Dewesoft. The solution brings a simple and intuitive measurement process while offering the utmost precision and industry unmatched adaptability.
-
Product
Digital Instantaneous Frequency Measurement Receivers
DIFM
-
Mercury Systems offers a range of standard high-performance broadband Digital Instantaneous Frequency Measurement (DIFM) receivers and Digital Frequency Discrimination (DFD), which act as functional building blocks in many military electronic warfare systems. Examples include electronic counter measures (ECM) systems, electronic surveillance measures (ESM) systems and radar warning receivers (RWR).
-
Product
Power Profiler, DC Energy Analyzer, Power Supply, Digital Multimeter, Source Measure Unit, Power Debugger
Otii Ace Pro
-
Otii Ace Pro is the big brother to Otii Arc, and is an instrument that can precisely source voltage (up to 25 V) and current (up to 5A) and simultaneously measures voltage and/or current with a high sample rate (50ksps) and low step size. It computes power and energy and enables engineers and developers to easily see and optimize the energy consumption and battery life of their devices under test.
-
Product
Horizontal Measuring Instruments
TELS
-
The Mini-Horizontal TELS is the ideal instrument for checking small dimensions. It is part of the horizontal instruments family.
-
Product
Current & Voltage Sources for Calibration of Measuring Systems and Sensors
-
ChenYang Technologies GmbH & Co. KG
*DC/AC Current: 0-60A *DC/AC voltage: 0-1000V frequency 50Hz, 60Hz, 400Hz, 1kHz
-
Product
Logger and Handheld Instruments for Temperature Measurement and Monitoring
-
Temperature measurement and monitoring is vital for the quality of temperature-sensitive products wherever they are studied, produced, stored or transported.
-
Product
Hall Effect Measurement System
RH 2010
-
The RH 2010 Hall Effect Measurement System has been designed for high flexibility and ease of use as a standard system for quick routine control measurements as well as for sophisticated temperature dependent Hall measurements for material research.
-
Product
4 Point Probe Sheet Resistance/Resistivity Measurement with Temperature Controled System
TCR-600
-
*Controlled Thermo-chuck (room temperature～600℃/less than 20 minutes)*600C compatible probe head with 1mm linear*Controlled with vacuum sensor, digital thermo-meter, vacuum gauge and gas flow meter*Temperature measuring accuracy：±（0.5% + 1℃）
-
Product
Signal Converters For Temperature Measurement In Direct Drive Motors
EIB 5000 series
-
*Reduced cabling*Overload protection for direct drive motors*Faster response behavior for excessive temperatures*Greater cost-effectiveness
-
Product
Noise Figure Measurements With Vector Correction
S97029B
-
The instrument’s standard receivers are used for noise figure measurements with the S97029B. An external preamplifier and filter(s) is required for devices with < 30 dB of excess noise (gain plus noise figure in dB)
-
Product
Through Hole type DC Current Sensor／for Load Current Measurements
MOHT-400B Open loop method
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*Hall effect measurement for DC/AC/Pulsed current.*For the use of UPS, batteries, switching power supply, DC motor drivers, etc.
-
Product
Ultraviolet Light Distribution Measurement Film
UVSCALE
-
UVSCALE is a film that responds to UV light, and changes color depending on the amount of light it is exposed. This makes it easy to see UV light distribution. There are a roll type and a sheet type, with three types for different amounts of light.
-
Product
Vector And Scalar Mixer/Converter Measurements
S96083B
-
S96083A provides fully calibrated conversion gain/loss, relative phase, and absolute group delay measurements of mixers and converters without the need for reference or calibration mixers
-
Product
Multiparameter Measuring Systems
-
With the Modulyzer measuring systems you can obtain multiple parameters from one sample in only one measuring cycle. Combined with Anton Paar sample changers you can even analyze a multitude of samples in fully-automatic, single-run mode. Select from pre-configured but modular options for your specific industry and application. Anton Paar’s Modulyzer measuring system setups are as individual as your requirements. No matter how many instruments you integrate in your individual configuration, Modulyzer is operated via only one screen and delivers all the results you need at the push of a button.
-
Product
Measuring Microscopes, Image Processing
COMEF
-
Optik Elektronik Gerätetechnik GmbH
Image processing system.
-
Product
Specific Test & Measurement Solutions
-
Going beyond product ranges that meet relatively standardised needs, SPHEREA also designs custom solutions on a case-by-case basis, adapted to suit every issue.
-
Product
23KHZ Measurement Microphone
M23
-
The M23 is a precision engineered 23kHz omnidirectional measurement microphone ideally suited for acoustical measurements including loudspeaker design and quality control, sound system setup and troubleshooting, room acoustics, or any application where an accurate free-field measurement microphone is required.
-
Product
Color & Appearance Measurement
-
Konica Minolta Sensing Americas, Inc
Popular within research and manufacturing environments, our high performance, precise color measurement solutions help organizations formulate, evaluate, and control color to meet product quality and operational goals more efficiently. To see which solution best fits your application and operational needs, please browse through our selection of colorimeters, spectrophotometers, gloss meters, software and light booths below.
-
Product
Basic Pulsed-RF Measurements
S93025B
-
S93025B basic pulsed-RF measurements enables 4 internal pulse generators that can be used to control the internal pulse modulators (N522xB/N524xB Options 021/022), and provides an integrated pulse application that uses the wideband-detection method.
-
Product
Basic Sound Level Measurement System
-
The system utilizes a National Instruments CompactDAQ data acquisition device and the Nelson Acoustics Trident software application to provide a basic, computer based, sound pressure level measurement system.
-
Product
Measurement of Dew Point in Compressed Air Systems
HP480 – HP481
-
Compressed air is used for several purposes, many of which require compressed air with a low humidity level, and so comes the need to know the dew point (DP) of water vapour in the compressed air that circulates in the system.
-
Product
Measuring Instruments
-
Since acquiring the Kimo and E Instruments brands, we have added a comprehensive range of measurement instruments to the Sauermann product portfolio. These instruments are designed to monitor indoor air quality (IAQ) and combustion gas machines during installation and maintenance operations by measuring concentrations of gases and other substances in the air.
-
Product
Ultrasonic Level Measurement
VeriGAP
-
Ultrasonic technology is a great choice for high or low-level liquid level measurement requirements in a wide variety of liquids. These ultrasonic sensors require no calibration and are not affected by changes in electrical properties of the material being measured.
