-
Product
FieldFox Handheld Microwave Spectrum Analyzer, 26.5 GHz
N9938A
Spectrum Analyzer
100 kHz to 26.5 GHz frequency range Expand capabilities with optional tracking generator, interference analyzer, built-in power meter, and more Make accurate spectrum analyzer measurements ( 0.5 dB) without needing warm-up Locate interfering signals using the intuitive spectrogram display and recording capability Easily measure average and pulse power with a USB power sensor, pulse measurements with time gating Lightest microwave handheld spectrum analyzer at only 6.6 lb. (3.0 kg)
-
Product
PCIe 6.0 Protocol Analyzer
P5570A
Protocol Analyzer
Keysight PCIe 6.0 Protocol Analyzer redefines protocol debugging and validation through a new innovative CEM card form factor, bringing vast improvement in signal integrity and equalization with instant link-up to systems as well as devices under test
-
Product
Rapid Protein Analyzer
SPRINT
-
Bioscience meets food science with CEM’s new SPRINT™ Rapid Protein Analyzer for fast, accurate protein testing. This patent-pending system, which uses iTAG protein-tagging technology, identifies and measures only protein, not nitrogen, so you can be certain your results are accurate.
-
Product
Logic Analyzer Probe
FS2521
-
The FS2521 is a logic analyzer probe used to test DDR4 SO-DIMM memory. When used with the triggering and analysis capabilities of Keysight’s U4164A logic analyzer modules, it gives the user an extremely effective tool for debugging, testing and verifying DDR4 SO-DIMMs. Now qualified at 3200MT/s
-
Product
PXIe-5663E, 6.6 GHz PXI Vector Signal Analyzer
781260-02
Signal Module
6.6 GHz PXI Vector Signal Analyzer - The PXIe‑5663E offers wide instantaneous bandwidth and supports RF list mode, which increases multiband measurement speed with fast and deterministic changes in configuration. You can use a PXIe‑5663E as either a spectrum analyzer or vector signal analyzer, and you can use it with the Modulation Toolkit to analyze custom and standard modulation formats. The PXIe‑5663E can perform measurements for a broad range of communications standards such as GSM, EDGE, WCDMA, WiMAX, LTE, Bluetooth, WLAN, DVB‑C/H/T, ATSC, and MediaFLO. Because all measurements are software defined, you can reconfigure the measurements using standard-specific toolkits. With these toolkits, the PXIe‑5663E provides a low-cost solution to high-performance RF measurements.The PXIe-5663E comprises the following modules:• PXIe-5601 RF Signal Downconverter• PXIe-5622 IF Digitizer• PXIe-5652 RF Analog Signal GeneratorThere is no physical device named "PXIe-5663E".
-
Product
PC Analyzer / Debugger
RapidDriver Explorer
-
RapidDriver Explorer is an intelligent tool for PC hardware analysis and debugging. RapidDriver Explorer allows you to start working with your hardware device with just a few clicks of the mouse. Simply install your new hardware, create a new RapidDriver project, and then select your device from the list of PnP devices auto-detected by RapidDriver.
-
Product
Photolysis Rate Analyzer
PFS-100
-
, HONO, HCHO etc.) are key indicators for identify status & extent of photochemical pollution.The analyzer is receiving solar radiation by quartz probe and transferring the radiation to spectrum via optical quartz fiber, the spectrum data will be evaluated and compared with reference data with mathematical approach and gives photolytic rate.
-
Product
On-line TOC Analyzer
TOC-4200
-
The TOC-4200 is a high-performance on-line TOC analyzer, based on the proven 680°C Catalyst-aided Combustion technology. This established technology is featured in a large installed base of Shimadzu Total Organic Carbon Analyzers throughout the world, and has been applied to a broad field of industries.
-
Product
CS/ONH Analyzers
-
Elemental analysis of CS and ONH in inorganic materials | Based on the know-how of many decades Bruker offers innovative solutions for rapid and precise elemental analysis of carbon, sulfur, oxygen, nitrogen and hydrogen.
-
Product
Bus Analyzer
FireStealth® FS810bN
-
DapTechnology’s FireStealth810bN with its non-intrusive bus monitoring technology is the world’s first “Stealth Mode” IEEE-1394b analyzer. The FireStealth IEEE-1394b analyzer is a bus monitoring device that is attached to the IEEE-1394b bus leaving the existing topology unaffected.
-
Product
Force Distance Tester
925
-
The Model 925 is a low cost force-distance tester. It communicates with a Windows™-based PC to send data into an Excel format. The data can then be viewed and analyzed in tabular or graphical format. Once in the Excel format, the data can be transferred or used in any of the multiple Excel operations. This line of displacement-force test stations has a positional resolution of 0.0025 mm (0.0001 inches). Your test department will appreciate the high accuracy readings provided over the complete travel range.
-
Product
Trace Oxygen Analyzer
GNL-IN121
-
Shanghai ChangAi Electronic Science & Technology Co.,Ltd
GNL-IN121 is based on microprocessor, and keeps frequency current sensor as measuring point with intelligence, high accuracy and comprehensive function. It applies to the accurate measurement of oxygen concentration in 0~25.00% nitrogen- oxygen mixed gases. - See more at: http://en.ci-ele.com/8aedb8bf-ef48-4f8c-127a-797c939a6181/0e266f3f-134f-bfa1-4437-f6ee37fdb1dc.shtml#sthash.sNvnkmUs.dpuf
-
Product
Gas Online Analyzer
OMA-100
-
OMA-100 gas online analyzer is a new generation of online gas analyzers which was independently developed based on the world's leading non-dispersive infrared gas analysis technology. It adopts a half-air chamber gas circuit design, with higher measurement accuracy, lower drift, and less influence from external interference (temperature fluctuati
-
Product
Constant Volume Sampler
CVS-ONE
-
The CVS-ONE series is designed for the measurement of diluted emissions from vehicles and engines. The new integrated operating platform, HORIBA ONE PLATFORM is adopted for the CVS-ONE. The hardware has been significantly downsized from previous designs, reducing test cell footprint requirements. It introduces new functions and is more user-friendly, while still maintaining high accuracy. In conjunction with the MEXA-ONE (Motor Exhaust Gas Analyzer), the system can be used to measure extremely low emission levels such as SULEV. The new CVS reliably supports emission testing requirements of today and into the future.
-
Product
Field-installation Type MLSS Meter (Four-Wire Transmission)
HU-200SS
-
HU-200SS connects immersion type MLSS sensor (SS-90) and measures MLSS in activated sludge. A wide range (0-2000mg/L)of SS contents can be measured with excellent reproducibility using the near-infrared radiation transmission method. Any of the calibration curves of MLSS, Clay (inorganic mud) and Kaolin may be used as standard substances of SS. If "MLSS" is selected for an activated sludge treatment tank, "Clay" for the precipitation treatment of construction sludge, or "Kaolin" for white mud, a concentration can be obtained closer to an analyzed value.
-
Product
CAN/LIN Communications Expansion Kit
OP-SB87
-
OP-SB87 is an expansion board for CAN/LIN communications, inserting into a slot of communication analyzer LE-8200A/LE-8200. It has 2 CAN connectors and 2 LIN connectors, and measures 2 channels of CAN or LIN, or 1 CAN/1 LIN. It is useful to measure network where there are CAN and LIN communications at the same time.
-
Product
Central Office Line Simulator
AI-7280
-
The AI-7280 is a highly flexible central office line simulator. It is designed primarily for the testing and verification of common terminal equipment, including standard telephones, Caller ID devices, SMS (Short Message Service) capable equipment, and any device using an analog Tip/Ring interface circuit. Supplied with the TRsSim software for Windows, it can analyze a telephone''s DTMF characteristics, pulse dialing and flash timing, generate various network tones and ringing patterns. Both Type I (on-hook) and Type II (off-hook) Caller ID is supported using either FSK or DTMF data transmission. As an optional component, the TRsSim software can perform SMS testing to either the ETSI protocol 1 or protocol 2 standards.
-
Product
Environmental, Dairy & Agri-Food
-
Automated analyzers using either direct-read discrete or continuous flow technologies offer a broad range of tests and capacities for beverages and all types of water analysis, including municipal, wastewater, and fresh and ocean sources. For the production of cultured dairy products, unique continuous pH monitoring solutions provide a complete fermentation profile to ensure culture consistency.
-
Product
HAAS-2000UV High Accuracy Array Spectroradiometer (Laboratory Grade)
-
Hangzhou Everfine Photo-E-Info Co., LTD
HAAS-2000 is the world's most advanced high accuracy array spectroradiometer, ultraviolet special wavelength can not only be used for pure ultraviolet radiation analysis, but also can accurately obtain ultraviolet effective content, ultraviolet spectral irradiance and other parameters. The instrument has high sensitivity in the ultraviolet wavelength, fast measurement speed, can obtain ultraviolet spectra under transient conditions, and can accurately analyze the change of spectra with time.
-
Product
Protocol Analyzer
-
Zeroplus Technology Corperation
Is a measurement tool or device used to capture and monitor the data over communication channel.
-
Product
Time Domain Analysis
S97010B
-
The S97010B time domain analysis capability allows you to measure the time domain response of a device. The analyzer can transform frequency domain data to the time domain or time domain data to the frequency domain.
-
Product
Field Comm Analyzer
S5800H
-
S5800H Series Field Comm Analyzer is an 8.4 inch large touch screen instrument which is designed specifically for wireless communications field engineers and technicians. S5800H series provide all necessary measurement functions and performance to accurately characterize the signal environment in addition to clearing, detecting, identifying and locating signal interferenc.
-
Product
Vapor Sorption Analysis
-
Vapor Sorption Analysis is a technique in which a sample is subjected to varying conditions of humidity and temperature, and the response of the sample is measured gravimetrically. Understanding the effects of water content on structure and properties is critical in the development, processing and end use of a broad spectrum of materials. TA Instruments offers the most sensitive, versatile, and productive moisture sorption analyzers on the market. The Discovery SA combines a high-sensitivity thermobalance, innovative humidity control chamber, and reliable autosampler. Innovative technology combined with our unparalleled reputation for service and support make TA Instruments the clear choice of scientists worldwide for vapor sorption studies.
-
Product
Continuous Time Interval Analyzers
GT668PXI-15
-
GuideTech’s GT668PXI-15 PXI 3U form factor, meets industrial standard chassis with an expandable platform, achieving optimal test system at low cost. High accuracy 50MHz time base with NIST traceable calibration.
-
Product
CAPS True NO2-NOX-NO Analyzer
Model N500
-
Teledyne Advanced Pollution Instrumentation
The Model N500 CAPS NOx analyzer uses superior Cavity Attenuated Phase Shift (CAPS) Spectroscopy to measure True NO2, NOx, and NO gases. The instrument combines direct NO2 measurements with highly efficient gas phase titration (GPT) to convert and measure the NO gas component. An automatic baseline reference cycle accounts and compensates for any potential baseline drift due to varying environmental conditions.
-
Product
Portable Multi-channel Waveform Monitoring Recorder
MR1200 Series
-
The portable waveform monitoring recorder is a device for recording and analyzing the change process of electrical signal related parameters of the power system.
-
Product
Non-Intrusive voice Quality Analyzer
NIQA
-
The most known methods for quality evaluation of voice transmission systems were developed by Telecommunication Standardization Sector of International Telecommunications Union (ITU-T) in the middle of 90-s. Results of this work are presented in Recommendation P.800 (P.830) «Methods for subjective determination of transmission quality» [1, 2]. This document describes conditions for voice quality testing, audio contents, scoring and methods to evaluate results. Typically “Methods for subjective determination of transmission quality” are used to obtain mean subjective quality score according to five-digit scale (Mean Opinion Score – MOS).
-
Product
XRF Instruments
-
FISCHERSCOPE® X-RAY XRF measuring instruments are exactly what you need. Precise, fast, reliable and durable: Measure coating thicknesses and analyze materials non-destructively, contact-free and conveniently. The instruments are easy to use and suitable for almost any application.
-
Product
Wet Oxidation TOC Analyzer
TOC-VWP
-
Phosphoric acid and the oxidant (persulfate) are added to the sample, which is heated under UV illumination to convert the TC in the sample to carbon dioxide. This carbon dioxide flows with the carrier gas via the dehumidifier into the NDIR sample cell. The area of the carbon dioxide peak signal is measured and this peak area is converted to TC concentration using a pre-prepared calibration curve.
-
Product
Microphone preamplifier
PRE-01
-
The microphone preamplifier PRE-01 has been designed to match Audiomatica’s microphones MIC-01, MIC-02 andMIC-03. It is particularly useful when the microphone has to be operated far from the analyzer or when weighted measurements are needed. PRE-01 powers the microphone connected to its input with an 8.2V phantom supplyand adds a selectable weighting filter (A or B or C); also available there is a 20 dB gain stage
