Product

1U Rack Adapter for Series HSF-1U, HSF-1UR

RA 19

-

Kepco, Inc.

RA 19 - Kepco, Inc.

The 1U high rack adapter will mount four of the low profile 50W, 100W and 150W (Series HSF-1UR or HSF-1U) power supplies. Each plug-in power supply is equipped with a power on/off, indicator LEDs and voltage test points. The RA 19-1U provides access to the DIP switches and rack keying without disassembling the rack. It also provides a redundant scheme with modules 1 and 3 being powered from one a-c input and modules 2 and 4 from a second a-c input. Module numbering is left to right facing the front panel.

Product

Adapter For Sun Microsystems Computers

Ramcheck 200-Pin DIMM

-

INNOVENTIONS, Inc.

Ramcheck 200-Pin DIMM - INNOVENTIONS, Inc.

The RAMCHECK 200-pin DIMM Adapter allows you to test 200-pin FPM/EDO DIMM (Dual-Inline-Memory-Module) modules with a basic configuration of 144 bits, as used in the Sun Sparc Stations and other Sun Microsystem computers

Product

SysMon / Shelf Manager Adapter Board

042-751

-

ELMA Electronic, Inc.

042-751 - ELMA Electronic, Inc.

Adapter board for pluggable SysMon and Shelf Manager versions.

Product

PCI Express Mini Card Adapter for PCIe Slots

PCIe-mPCIe

-

Acces I/O Products, Inc.

PCIe-mPCIe - Acces I/O Products, Inc.

The PCIe-mPCIe Adapter is a practical solution for system developers when the target embedded system platform is not yet available, but our PCI Express mini card I/O board is, and you need to get started developing and testing the hardware and software.

Product

Debug Adapters

-

iSYSTEM ag

iSYSTEM ag

One thing is sure in the life of an embedded developer - your next microcontroller development board will be fitted with a different debug connector to the one used in your previous design.

Product

Multi-Protocol Test & Simulation Adapter for USB or Ethernet

EXC-UNET2/xx

-

Excalibur Systems, Inc.

EXC-UNET2/xx - Excalibur Systems, Inc.

The EXC-UNET2/xx is a multi-protocol test and simulation adapter for USB or Ethernet equipped computers. Its small size and ability to interface through USB or Ethernet interfaces make it a complete solution for developing, testing and performing system simulation of a number of communications protocols, both in the lab and in the field.Multiple units can operate via USB ports on the same computer. In addition, multiple units can operate on the same network, by programming each one with a unique IP address, and can be accessed from any computer on the network.

Product

cPCI to PMC Adapter / Carrier

cPCI2PMC

-

Dynamic Engineering

cPCI2PMC - Dynamic Engineering

The cPCI2PMC ( cPCI to PMC ) adapter / carrier converter card provides the ability to install a PMC card into a standard cPCI slot. The cPCI2PMC has a PMC card slot mounted to a universal 3U 4HP cPCI card. Suitable for 32/64 with 33/ 66 MHz bus operation. The PMC user IO connector Pn4 is optionally connected to J2 for rear panel IO. 

Product

Test Adapter

Ramcheck 100

-

INNOVENTIONS, Inc.

Ramcheck 100 - INNOVENTIONS, Inc.

This addition to the RAMCHECK memory tester provides needed support for testing of SDRAM and standard EDO/FPM DRAM 100-pin SO DIMM modules at an affordable price.

Product

Adaptive Relay Board, Virtex-6 FPGA - PCIe

Model 78624

-

Mercury

Model 78624 - Mercury

Model 78624 is a member of the Cobalt® family of high-performance PCI Express boards based on the Xilinx Virtex-6 FPGA. As an IF relay, it accepts two IF analog input channels, modifies up to 34 signals, and thendelivers them to two analog IF outputs. Any signal within each IF band can be independently enabled or disabled, and changed in both frequency and amplitude as it passes through the module. The 78624 supports many useful functions for both commercial and military communications systems including signal drop/add/replace, frequency shifting and hopping, amplitude equalization, and bandwidth consolidation. Applications include countermeasures, active tracking and monitoring, channel security, interception, adaptive spectral management, jamming, and encryption.

Product

ProBus Probe Adapter for TekProbe-BNC Probes

TPA10

-

Teledyne LeCroy

TPA10 - Teledyne LeCroy

- Allows TekProbe interface level II probes to work with any ProBus-equipped Teledyne LeCroy oscilloscope- Automatic probe detection- Provides all necessary power and offset control to the attached probe- Supports probes up to 4 GHz- Easy firmware updates- Wide variety of probes supported including: Preamplifiers, Current Probes, Single-Ended Active Probes and Differential Active Probes

Product

32-bit PMC to PCI Adapter

8092

-

ELMA Electronic, Inc.

8092 - ELMA Electronic, Inc.

This PMC to PCI Adapter permits delivery of PMC-derived applications in a standard PCI environment. Mechanically, a PMC card fits cleanly on a short-length PCI board, resulting in a highly acceptable delivery solution for desktop applications.

Product

External Contact Adapter

DT141

-

Fourier Systems

DT141 - Fourier Systems

This MicroLog sensor monitors Reed Relay contacts and switch status (open/closed), to identify the correlation between phenomena such as temperature change and door status.

Product

Passive XMC-to-PCI Express Adapter

6066

-

Technobox, Inc.

6066 - Technobox, Inc.

Our Passive XMC-to-PCI Express Adapter +5VPWR 4X (6066) is designed to adapt a single-wide XMC card to a 4X PCI Express slot. The 6067 supports P15 only and allows access to PN4 signal via the adapter's DIN connector. The A and C rows of a 96-pin DIN connector connect with the 64-pin user I/O connector (J4/P4) on the mezzanine card.

Product

USB I2C Adapter

MS (Master & Slave)

-

Coptonix GmbH

MS (Master & Slave) - Coptonix GmbH

*Plug & Play*No additional driver necessary*HID device drivers are included in major operating systems*Open interface description enables communication without a DLL

Product

Production PCB Combinational Tester

-

Intellitech Corp.

Intellitech Corp.

The PT100Pro combines ARM Functional Test, Analog Test and Boundary Scan in one platform for testing up to 32 PCBs at a time. The PT100 Pro solves the test challenges and cost requirements of testing small, high-volume PCBs used in the home, mobile, entertainment, automotive and embedded markets. PCBs in these markets are cost sensitive yet require high volume, high fault coverage on leading edge technologies such as WiFi, DDR Memory, USB, Bluetooth, Nand Flash, MPEG decoders, Power Management Units, and MMC/Smart Cards interfaces.

Product

Coaxial Waveguide Adapter, 1.85 mm (m), 40 to 60 GHz

U281B

-

Keysight Technologies

U281B - Keysight Technologies

The Keysight U281B adapter transforms waveguide transmission line into 50-ohm coaxial line. Power can transmitted in either direction, and each adapter covers the full frequency range of its waveguide band with SWR less than 1.3.

Product

NF-SF 50 N-Female to SMA-Female Adapter

-

Copper Mountain Technologies

Copper Mountain Technologies

NF-SF 50 Adapter, N-Female to SMA-Female, Frequency Range: DC to 18 GHz, Impedance: 50 Ohm

Product

64-bit PMC To PCI Adapter

8096

-

ELMA Electronic, Inc.

8096 - ELMA Electronic, Inc.

This 64-bit PMC to PCI Adapter permits delivery of PMC applications in a standard PCI environment. PMC suppliers can introduce products to desktop packaging without having to maintain two PCI-based designs — one for standard PCI and a second for PMC.

Product

Design, Manufacture & Test of Complex RF/Microwave Printed Circuit Boards (PCBs)

-

Teledyne Defense Electronics

Teledyne Defense Electronics

Teledyne Labtech specialises in the design, manufacture and test of complex RF/Microwave printed circuit boards (PCBs). - Technology driven – we innovate- Turnkey - one stop for manufacture, assembly & test- Focused – technical design support for RF/microwave and large format PCBs

Product

PCB GPTA02, 10 mV/g, IEPE, 1 Hz to 5 kHz, Accelerometer, Triaxial Vibration Sensor

784169-01

-

NI

784169-01 - NI

The PCB GPTA02 helps you acquire sound and movement data with supported PXI Sound and Vibration Modules, C Series Sound and Vibration Input Modules, and USB-based Sound and Vibration Devices. This sensor uses the Integrated Electronics Piezo-Electric (IEPE) current excitation. The PCB GPTA02 features a sensitivity range of 10 mV/g and requires a 4-socket plug-to-3 BNC plug cable.