Airborne
See Also: Aviation, Avionics, Radar Target, Countermeasure
-
Product
Airborne Ultrasound Sensors
-
Find compressed air, gas and vacuum leaks in noisy environments. Increase your inspections distance and reach hard to access areas.
-
Product
Airborne Frequency Converter
AFC Series
-
Behlman’s AFC-7000-1 & -2 and AFC-7003, frequency converter are designed to convert three-phase aircraft power to regulated single-phase (115 or 230 VAC) or three-phase (115/200 VAC) at 50 Hz, 60 Hz or 400 Hz. They are ruggedly built to support aircraft takeoffs and landings and designed to meet the input power requirements of MIL-STD-704 and RTCA-DO-160.
-
Product
Airborne Receiver
MS 2015
-
Receiver shall receive the telemetry signal transmitted by the airborne TGS unit. This unit is a single conversion super heterodyne FM receiver operating at 1486.5MHz. This unit has four connectors. They are RF input connector (J1), Power connector (J2), Signal connector (J3) for AGC signal and a Video output connector (J4). This unit operates at 28V DC and consumes a typical power of 5.6 watts.
-
Product
Airborne Gravimeter
GT-1A
-
The GT-1A airborne gravimeter brings proven design and fully automatic operation to mobile scalar gravity measurement. Intelligent Platform Control combined with continuously recorded wide dynamic range allows the collection of high quality data through periods of turbulence. Proprietary software provides on-side delta-g values for post-flight evaluation.
-
-
Product
Airborne Computers
-
True open systems architecture leverages commercial, off-the-shelf technology, in a high-performance, scalable, and maintainable solution for future applications and next generation computing capabilities. Our mission processor's open architecture is suited for multiple platforms, providing advanced general and display processing for current and future needs.
-
Product
Airborne Video Delay Board
MS 2006
-
- Spartan FPGA based Design- Customized design for delaying & switching video inputs to RF section- Interface with EW Signal Processor Unit- Two channel video inputs and control- Video Signal Delay from 1ns to 1ms- Over duty Indications- Inhibit Control- Discrete Interface
-
Product
Airborne Network Flight Recorder
TTC nREC-4000S
-
Curtiss-Wright Defense Solutions
The TTC nREC-4000S-2 is an intelligent IP flight recorder. The unit records data from network-based data acquisition and multiplexing devices and, with built-in intelligence, supports extensive recorder statistics and provides continuous health monitoring.
-
Product
Automated Monitoring of Airborne Molecular Contamination
AMC-Monitor T-1000
-
The all-in-one analyzer for FOUP, fab and clean-room environment AMC monitoring in the semiconductor industry. The AMC-Monitor is a modular and flexible platform for airborne molecular contaminations (AMC) monitoring in semiconductor applications such as: FOUP analysis with a focus on VOC and condensables incl. full integration with Pfeiffer Vacuum APA 302 pod analyzer. Clean-room monitoring in fabrication plants.
-
Product
Integrated Airborne Solutions
-
UAVs have evolved into the 'Go-To' platform for many remote-sensing applications. Headwall's integrated solutions combine a hyperspectral imaging sensor and choice of GPS/IMU mounted on a high-performance UAV.
-
Product
Airborne Network Flight Test Recorder
TTC nREC-7000
-
Curtiss-Wright Defense Solutions
The nREC-7000 is a high speed network recorder for use with Flight Test Data Acquisition and Multiplexing units. The nREC-7000 accepts data for recording on two 10GBASE-SR ports and two 1000BASE-T ports that can store data at sustained speeds of up to 1,000 MBps per 10GbE port. The recorder is also capable of acquiring, formatting (using PCAP, DARv3 or IRIG-106 Chapter 10/11), and recording 10GBASE-SR Ethernet at line rate.
-
Product
Precise Measurement of Airborne Noise Insulation
Isokell
-
Isokell offers a flexible method geared specifically to the needs of the automotive industry for measuring airborne noise insulation and the transmission loss of vehicle components. The system is easier to use and less costly than traditional acoustic measurement systems.
-
Product
Airborne Receivers & Bit Synchronizers
-
The Lumistar LS-28-DRSM Series Multi-Mode Multi-Band Receiver/Combiner/TM Processing Unit is designed using ruggedized packaging to survive severe airborne conditions. The LS-28-DRSM is available in several configurations: 1) Airborne receiver only (RF to bits), 2) Airborne bit synchronizer only, 3) RF to TM Processing and Display (RF to bits to UDP decom to LAN Client Displays). Models with receivers are available in any band form 200 MHz to 7 GHz with S, lower L and C bands as standards. Other RF bands are available, please consult the factory for details. This unit can be mated with other Lumistar products to provide a complete air-to-ground re-transmission system.
-
Product
Single / Dual Power PC
DP-VME-0447
-
DP-VME-0447 is a Single/Dual Power PC7448/7447A SBC.This dual or single processor VME-bus computer to meet needs of high performance embedded applications. It addresses such markets as defence, aerospace and automation, where real-time control signal processing is required. Applications for this board include VME computers, signal processing units, airborne system controllers, and automation systems.
-
Product
Ruggedized Small-Size Telemetry System, Requiring Laptop for Display and Control
LS-84-EC
-
The Lumistar LS-84-EC “Economy Chassis” Telemetry System offers a low cost, high performance COTS solution for a portable quick look ground/remote/airborne station. The unit has a built-in computer running Windows 10 (WIN 7 option) for stand-alonecontrol or can be controlled remotely over TCP/IP. Using Lumistar’s PCI-based or modular line of telemetry products, acomplete telemetry ground station can be configured in a very small space. Functions such as RF reception, demodulation, bitsynchronization, simulation, frame sync, decom, data archive and real-time display can all be handled in this unit. Data can bearchived on an internal solid state drive or external serial ATA or USB 2.0 drive. A laptop using a network connection providesremote control and access to real-time displays. The I/O connections from individual PCI cards are hardwired internally within the chassis, thus allowing a bulkhead mount configuration on the rear panel of the chassis.
-
Product
Digital Ultrasonic Maintenance System
VPE-2000
-
The Superior AccuTrak VPE-2000 is the first digitally controlled ultrasonic detector. Like two instruments in one it uses two independent sensors supported by separate electronic circuits configured specifically to their own sensor. This assures optimum sound clarity and frequency response. When switching between the airborne and contact sensors all settings are retained in memory! Digital LED meters let you establish baselines, perform trending, and accurately repeat these tests better than older more expensive analog instruments.
-
Product
Data Monitoring System
1S663-001
-
The 1S663-001 Data Monitoring System was specifically developed for the Cessna Citation X and serves as the primary diagnostic tool for the aircraft?? electronic Logic Modules. The system is FAA certified for airborne operation. Aft compartment and cabin modules can be tested two at a time while remaining in place. The system is also capable of monitoring the fuel quantity system during flight.
-
Product
Frequency Sources
-
PMI offers a full line of Digitally Controlled Oscillators (DTOs), Dielectric Resonator Oscillators (DROs), Voltage Controlled Oscillators (VCOs) and Frequency Synthesizers covering various frequencies in the 50 MHz to 40 GHz range. All models are designed to withstand stringent military ground or airborne environments. These models use the latest internal digital calibration techniques such that frequency drift over the operating temperature range is minimal. All units offer fast switching speeds and stable frequency outputs with low phase noise. If you do not see exactly what you need, please e-mail your requirement to sales@pmi-rf.com so we can propose an instant solution.
-
Product
Sound Monitoring & Matching API based on Sound Similarity Measurement (for Sound Recognition Projects)
-
Sound recognition is one of the main application areas of artificial intelligence. Various sound recognition techniques exist and can be used for recognizing speeches, music, environmental sounds, animal sounds, air-borne or structure-borne machine sounds, etc. These techniques contain in common signal pre-processing, feature extraction and feature matching / classification algorithms from a general perspective. However, they differ in implementation in different applications. For example, there are a few good automatic speech recognition software products and APIs, however, they just cannot be used directly in animal sound classifications.
-
Product
Timing Controller
MS 2009
-
MS5128 Timing Controller has programmable logic generation, Input Output Signals Interface, Timings, macro-cells, Pins, internal timing delay and Signal Levels for airborne microprocessor boards.
-
Product
12" Cable
CONA615-2
-
A 12" cable transitions from an ARINC 615 Data Loader Cable Connector (JT01RE-18A-53S) to an ARINC 603 Airborne Computer Connector (MS24266R-18B-31P)
-
-
Product
IFE Servers
CabinPinnacle
-
The Astronics CSC CabinPinnacle™ airborne server is a complete, highly integrated, application-ready platform for Ethernet-based cabin network installations.
-
Product
Rotary Joints
-
In addition to space applications, CAES rotary joints are used on many different platforms throughout the world, including ground-based and airborne advanced military radar, telemetry and air traffic control systems.
-
Product
Type 12R2, 5U, 19" Rackmount, MIL-Rugged, Horizontal
12R2-5U-H
-
The 5U, 12R2 is designed to meet the harsh environments of shipboard, airborne, and ground mobile applications per MIL-STDs. Shock isolated versions are designed to attenuate 25G shock inputs to the chassis to less than 10Gs at the card cage.
-
Product
Low Light Imagers for Defense
-
Teledyne Imaging addresses low light imaging applications with a range of standard CMOS and EMCCD image sensors suitable for defense and security surveillance systems, whether for battlefield, vehicle, airborne, CCTV or security day camera’s.
-
Product
Electrical Inspector
-
The UL101 Electrical Inspector utilizes airborne attachments to safely inspect sealed electrical panels and substations. The UL101 Electrical Inspector allows for early, long-distance detection of arcing, corona discharge, and tracking. Save time and money by reducing transmission/distribution loss and outages.
-
Product
Hyperspectral Imaging Sensors
-
HYPERSPEC® sensors are line-scanning instruments (sometimes called pushbroom) that collect reflected light through an image slit. One row of spatial pixels is collected per frame as motion occurs, with each pixel containing full spectral data. Motion can be accomplished in two ways: either as an airborne deployment (UAV, aircraft, or satellite) or stationary (where motion is accomplished beneath the sensor, such as a food inspection line). A third option is also available where pan-and-tilt or rotary stages allow a fixed-location sensor to scan a stationary object (such as a piece of artwork, or a mine face for geological applications).
-
Product
Digital Video Recorder
-
Elbit Systems of America is the industry leader in video, audio, and data recorder's for fixed and rotary platforms. Our compact Digital Video Recorder (DVR) enables recording video and audio channels on a solid state memory cartridge. Based on commercial off-the-shelf components, the DVR complies with stringent airborne data recording and mission debriefing requirements. Each DVR’s advanced design has no moving parts assuring high reliability in all conditions. With built-in growth potential, it is configurable from one to four video channels and can accommodate additional communications. The unit operates as a stand-alone system or integrates with existing systems and upgrade programs. Elbit Systems of America provides advanced solutions for the following fixed-winged and rotary platforms:
-
Product
Airborne Gravimeter
GT-2A
-
The very large dynamic range provides high precision data even in turbulent flying conditions; data is acquired through short periods of saturation in extreme turbulence by the automatic application of a reduced order Kalman filter, enabling platform misalignment to be computed and hence controlled; the automatic calibration program computes accelerometer scale factors and errors in perpendicularity between the accelerometer sensitive axis and the platform surface. The GT-2A installation in a fixed wing aircraft is shown in Fig 1 (courtesy of Excalibur).
