Product

4-Band SAT-IF Overlay Direct Modulated Optical Transmitter

HDS-55S ( 950~5500MHz )

-

Hangzhou Huatai Optic Tech. Co., Ltd.

HDS-55S ( 950~5500MHz ) - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai HDS-55S series 1550nm wide band micro-wave internal modulation optical transmitter， RF working 950~5450MHz.It cam It can transmit multi( stacker) 4 way SAT-IF signal in one fiber to realize two polarized 4 way SAT-IF signal in one satellite。or 4 way SAT-IF signal in different satellites to convert all of them into one fiber.。Through FTTH，users use ordinary satellite receiver and STB to receive satellite video carrier the integrate TV programs. It can supply high quality of satellite TV service up to 3000 SDTV or 600 HDTV channel.

Product

Optical Power Meter & VFL & RJ45 Network Test

TM263N

-

T&M Tools Limited Co

TM263N - T&M Tools Limited Co

◇ Added Network Cable Test ◇ Accurately test whether a single network cable transmits signals normally ◇ Self Calibration ◇ Set the Auto Off ◇ Wavelength Memory function after turn off the tester ◇ High Accuracy, high ,High sensitivity, high linearity ◇ Stable VFL Output ◇ USB Charge port ◇ FC,SC Connector ◇ 18650Li-ion Battery ◇ Lower power consumption design, long standby time ◇ Rubber Out shell, increased the protective properties for field work

Product

OEM 1-Channel Fiber Optic Signal Conditioner PCB Module

FOTEMP1-OEM-MNT

-

Micronor Sensors

FOTEMP1-OEM-MNT - Micronor Sensors

The FOTEMP1-OEM-MNT is a small form factor PCB interface module designed for low cost insertion of high precision GaAs-based fiber optic temperature sensor technology into OEM applications where common electrical temperature sensors and thermocouples cannot be used. The OEM interface product is compatible with all TS series fiber optic temperature probes. The sensors are entirely non-metallic and electrically passive, providing immunity to EMI, RFI, MR, microwaves and radiation is required.

Product

Optical Spectrum Analyzer

ID OSA

-

ID Photonics GmbH

ID OSA - ID Photonics GmbH

This instrument is a versatile Optical Spectrum Analyzer (OSA) based on a coherent detection principle provides picometer class spectral resolution across the C-Band (1528.5 – 1567.5nm).

Product

Optical Fiber 2×2 Switch

OFSW - 2 × 2

-

Hangzhou Huatai Optic Tech. Co., Ltd.

OFSW - 2 × 2 - Hangzhou Huatai Optic Tech. Co., Ltd.

OFSW-2 × 2 is a 2 × 2 prism optical switch. It can support 2 optical fibers input and 2 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.

Product

Optical Fiber Cables

-

Wuhan Sunma Technology Co., Ltd.

Wuhan Sunma Technology Co., Ltd.

Fiber Optic Cable comes in lots of types, depending on where it will be installed. Where to buy fiber optic cable? As the best OEM fiber optic cable manufacturer, SunmaFiber provides a wide range of quality optical fiber cables with detailed specifications displayed for your convenient selecting. Per foot price of each fiber cable is flexible depending on the quantities of your order, making your cost of large order unexpected lower. Customers can also have the flexibility to custom the cable plant to best fit their needs. Only fiber cable that meets or exceeds industry standards is used to ensure quality products with best-in-class performance.

Product

Rugged Rectangular Fiber Connectors

-

TE Connectivity Ltd.

TE Connectivity Ltd.

TE Connectivity (TE) has a range of rectangular fiber connectors for rugged environments including the ARINC and MTCT connectors. Whether you are designing collision avoidance systems, in-flight entertainment, or air-to-ground communications, you face a challenging economic environment and an ever-increasing demand for weight reduction. TE's ARINC 600 next generation receptacle connector allows you to reduce both weight and costs. TE's MTCT connector is a compact, lightweight design connector for use with ARINC 801 fiber optic termini. Ideal for applications such as avionics, in-flight entertainment systems, communications, production breaks and other areas.

Product

Erbium Doped Fiber Amplifier

S-102

-

Notice

S-102 - Notice

The EDFA slot module of FOTS system with built-in power booster EDFA module offers a special function that is able to change the optical signal amplification feature variously, which is followed by user’s driving embedded pump LD freely. The output power of eash pump LD can be controlled separately by the program that is set up by user. When an optimum optical signal amplification particularity is needed, it is made up so that it can be materialized by choosing the Default mode provided along with User mode. More stable application of EDFA is possible through the monitoring of the factors such as in/out signal power, gain, alarm status and pump LD enabled by the application of FPGA processor which makes high speed driving possible. It is also set up that user’s present-time monitoring and control through LCD monitor of system main frame or GUI display for remote control can be possible. Through optimization of amplifier gain, noise figure, and saturated output power, this EDFA module will expand test capabilities in systems, components or sub-assembly manufacturing.

Product

Optical & Electrical Data/Pattern Generators

-

Optellent, Inc.

Optellent, Inc.

The Data/Pattern Generators offer both electrical and Optical outputs with standard and custom data patterns. PPG products cover data rates ranging from 100 Mb/s to 28.05 Gb/s.

Product

4-Band SAT-IF & CATV Overlay Direct Modulated Optical Transmitter

HDS-55A ( 47~862 & 950~5500MHz )

-

Hangzhou Huatai Optic Tech. Co., Ltd.

HDS-55A ( 47~862 & 950~5500MHz ) - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai HDS-55A series 1550nm wide band micro-wave internal modulation optical transmitter, HDS-55A's working bandwidth covering range is 47~862 & 950~5500MHz. It can transmit multi (stacker) 4-way SAT-IF signal and CATV signal by a fiber, to realize one satellite-four polarization-4 way SAT-IF signal of 950~5500MHz (or different satellite 4 way SAT-IF signal), and 47~862 MHz CATV signal, all replacement a fiber to transmit. Users can simultaneously receive all full TV contents of satellite video carried and CATV's analog digital TV. It can provide high quality satellite TV and CATV service up to 3000 SDTV or 600 HDTV channel.

Product

950~2600MHz Satellite L-Band PIN Optical Receiver

HRS-26S/P

-

Hangzhou Huatai Optic Tech. Co., Ltd.

HRS-26S/P - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai HRS-26S/P optical receiver, adopting high-sensitivity PIN detector, receiving sensitivity is -22dBm, typical value: -13dBm. It can receive analogue and digital signal on satellite antenna LNB with the frequency of 950~2600MHz, It can be compatible with any FTTx PON to realize combination of Direct Broadcasting Satellite (DBS)with Internet and FTTH, it can also be used for L-Band uplink/downlink of satellite communication.

Product

Electro Optical Terahertz Pulse Reflectometry

EOTPR 3000

-

TeraView Ltd

EOTPR 3000 - TeraView Ltd

The EOTPR 3000 system is configured with a manual probe station to meet today’s tough FA environment which requires to isolate fault location in minutes rather than hours or days, while maintaining the EOTPR’s world leading sub-5 μm fault isolation accuracy.

Product

Optical Time Domain Reflectometer OTDR

BD300

-

Shanghai Baudcom Communication Device Co.,Ltd.

BD300 - Shanghai Baudcom Communication Device Co.,Ltd.

BD300 Optical Time Domain Reflectometerhas excellent dead zone performance and wide dynamic range. Combined with the visualfault locator, the OTDR can easily find the breaks, bends, splices, faultyconnectors, and other causes of signal loss.

Product

384x384 Port Software-Defined Optical Circuit Switch

SERIES 7000

-

Polatis, Inc.

SERIES 7000 - Polatis, Inc.

The Polatis Series 7000 Network Optical Switch is the largest-capacity, highest-density, highest-performance and most reliable non-blocking all-optical matrix switch available in the industry. The Series 7000 384x384 all-optical circuit switch is designed to meet the most demanding applications with exceptionally low optical loss, compact size, and fast switching speeds. With support for Software-Defined Networks (SDNs) via embedded NETCONF and RESTCONF control interfaces, the Series 7000n can route time-critical traffic with very low-latency to enable new virtual cloud services in hybrid packet-optical data centers. The Series 7000n is the latest addition to the Polatis product line of optical switches and modules, creating the broadest portfolio available of dynamic fiber cross-connect solutions (up to 384x384), all built on the Polatis’ patented DirectLight® optical switching platform that has been proven in the most challenging data center, telecom and defense and test applications for over a decade.

Product

Optical Clock-Recovery Modules / O-CR

-

multiLane

multiLane

Optical clock-recovery modules are required when a clock signal is not present to trigger the oscilloscope or when it is better to use the embedded clock present in the data stream, such as for 100G Lambda optical signals.Clock-recovery modules are essential for transmitter signal characterization.

Product

USB, Communications, Avionics And Optical Switching

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

From USB and Optical Switching to ARINC Switching

Product

Optical Receiver Stress Test

N4917BACA

-

Keysight Technologies

N4917BACA - Keysight Technologies

A complete, automated, and repeatable solution for optical receiver stress test.

Product

Optical Transimpedance Amplifiers

-

Analog Devices Inc.

Analog Devices Inc.

Analog Devices optical transimpedance amplifiers offer a complete, high performance, single chip solution for converting photodiode current into a differential voltage input. Supporting data rates from 155 Mbps to 11.1 Gbps, our transimpedance amplifiers are ideally suited for data communications and telecommunications applications supporting lay protocols including 1×, 2×, 4×, and 8× Fibre Channel, 10GBASE-LX4, SONET/SDH up to OC-192 with FEC, and 10 Gigabit Ethernet. Our transimpedance amplifiers feature low input referred noise current, high input current, and low power dissipation.

Product

Optics Test Systems

IR Autocollimator

-

Optik Elektronik Gerätetechnik GmbH

IR Autocollimator - Optik Elektronik Gerätetechnik GmbH

The infrared autocollimator was specially designed for the 1550 nm wavelength range. In conjunction with the CROSDETECT evaluation software, it achieves a measuring accuracy of 1 arcsec with a resolution of 0.1 arcsec. The camera used is suitable for the wavelength range from 900 nm to 1700 nm.

Product

Optical VSF Sensors

-

Sequoia Scientific, Inc.

Sequoia Scientific, Inc.

The optical Volume Scattering Function(VSF) is an ‘inherent optical property’ of water that is used by optical oceanographers to predict light propagation, image degradation, remote sensed ocean color, biological environment etc. in water.

Product

Fiber Identifiers & Talk Set

-

Fiberinthebox

Fiberinthebox

Fiber Identifiers and Talk Set are essential installation and maintenance instrument in data networks, CATV and telecommunication networks. Fiber identifier can identify the optical fiber by detecting the optical signals transmitted through the cables. Talk Set combines in one set the functions of both a digital optical phone and a stabilized light source. It is usually used in pairs, and can work over 80km. Fiberinthebox supply different types of Fiber Identifiers and Talk Set to meet you requirement, and they are with rechargeable battery and power supply adapter, so you can use them easily.

Product

Optically Isolated Measurement System

IsoVu

-

Tektronix, Inc.

IsoVu - Tektronix, Inc.

IsoVu offers complete galvanic isolation and is the industry’s first measurement solution capable of accurately resolving high bandwidth, low voltage differential signals in the presence of large common mode voltages. The stand out feature of IsoVu™ is its best in class common mode rejection across the entire bandwidth. Accurate differential measurements rely on a measurement system’s bandwidth, rise time, common mode voltage, common mode rejection capability, and the ability to connect to smaller test points to characterize devices that are shrinking in size and increasing in performance. Despite these requirements, advancements in test and measurement for power testing, EMI testing, ESD testing, and remote measurement capability have been minimal at best and have not kept pace with changing requirements. While differential voltage probes have had modest performance gains in regard to bandwidth, these probes have failed to make any substantial improvements in regard to common mode rejection, and connectivity. IsoVu is a leap forward in technology and is the only solution with the required combination of high bandwidth, high common mode voltage, and high common mode rejection to enable these differential measurements.