-
-
product
8-Pin Power D-Type Connector & Cable Accessories
Our 8-Pin D-Type connector is used on PXI and LXI switching products to provide a low density user connector solution. A 4-pin partially populated version of the 8-pin D-Type connector is also provided to match the connector pin assignment of our model 40-170 High Power Relay Module.
-
-
product
Cable Assembly 68-Pin Micro-D Male to Unterminated, Ferrules, 1m, Spring Latch
A068SMR-F-5B100
The 68-Pin Connector to Unterminated Cable Assy is constructed from 7/36 (28AWG) twisted pair wires with polypropylene insulation. The wires are colour coded to match the connector pin designation. The connector can be secured to the product by a Metal Spring Latch.
-
product
Cable Fault Locator
TX4000
Auto Fault Location Rugged Palm-Top design Weighs less than 350g (12oz) 11 Measurement Ranges up to 4000m 25, 50, 75 & 100ohm Selectable Cable Impedance User Variable Gain Control Built in Tone Generator for Pair Tracing and Identification Suitable for testing all Communication and Power Cables Environmental Protection IP54 CE Approved Soft bag & Test Leads
-
product
SH37F-Tajimi Shielded Cable, 10M
199254-10
37-Pin D-SUB Female to 4 7-Pin Tajimi Female, C Series Strain/Bridge Input Module Multifunction Cable - The SH37F-Tajimi connects with compatible sensors to accessories or cables with Tajimi push-pull connectors.
-
product
500-Pin SEARAY Cable Assembly, Male to 5x50-Pin D-Type, 2 Amp, 2m, 250 Port
A500RMR-05F050D5C200
The 500-Pin SEARAY connector is used on switching products to provide a very high density 2A connector solution that is suitable for use to 200VDC. The male SEARAY connector of this cable assembly is suitable for direct connection to Pickering Interfaces products. Five 50-Pin D-Type connectors allow an interface to other devices. Screwlocks are provided at both ends to secure the cable assembly to mating products.
-
product
Cable, 10 Pos Combicon to Pigtail, 1 Meter
190656-01
The SH10M-10F Cable, sometimes referred to as SH10F-P, connects C Series DAQ devices with a 10-pin screw terminal to open signal wires. The SH10M-10F Cable is offered in different lengths.
-
product
Multi-standard Cable/terrestrial Receiver For PCIe
DTA-2131
High-quality VHF/UHF receiver with support for all popular cable- and terrestrial standards, including ATSC 3.0, DAB, DVB-T2 and ISDB-T. The SDR approach enables full-channel reception (all services), advanced RF measurements and graphs.
-
product
Cable Assembly, 50-Pin D-Type, Female to Unterminated With Ferrules, 1m HV, Exit Towards Pin 1
A050DF5-F-HA100
50-Pin D-Type HV Cable assemblies are constructed from 7/0.2 (24 AWG) Tinned Copper Wire with PTFE Type C insulation. The connector assembly can be secured to the mating part by a screwlock. The 50-Pin Female connector options of this product can be directly mated to a corresponding Pickering Interfaces switching product.
-
product
Cable Assembly, 104-Pin D-Type, Male to Unterminated, Cut Ends, 2A, 0.5m
A104HMR-C-0A050
This 0.5m long male to untermiated 104-Pin D-type Cable Assembly is suited for direct connection to various products using the 104-Pin connector. It is constructed from high-flexibilty, high-specification fully screened cable and is unterminated with cut ends.
-
product
Cable Assembly, 50-Pin D-Type, Male to Unterminated With Cut Ends, 0.5m HV, Exit Towards Pin 1
A050DM5-C-HA050
50-Pin D-Type HV Cable assemblies are constructed from 7/0.2 (24 AWG) Tinned Copper Wire with PTFE Type C insulation. The connector assembly can be secured to the mating part by a screwlock. The 50-Pin Female connector options of this product can be directly mated to a corresponding Pickering Interfaces switching product.
-
product
Cable Assembly, 25-Pin D-Type, Female To Unterminated With Cut Ends, 0.5m
A026HF4-C-0A050
26-Pin Female to Unterminated D-Type Cable Assembly with Cut Ends. 0.5m Long.
-
product
Compact Cable Test Van
ETL-8
Van-based cable test and fault location system ETL-8 is used for testing cable insulation and locating cable faults using a variety of methods.
-
product
Cable Assy 68-Pin SCSI Micro-D M/F 0.5m
40-970-068-0.5m-MF
The 68-Pin SCSI Style Micro-D Cable Assembly is constructed from 7/36 (28AWG) Copper Wire with Polypropylene insulation. Metal Spring Latches are provided to secure the connectors to their associated products.
-
product
50-Pin IDC Connector for Ribbon Cable - Female
40-961-550-F
Ideal for user created termination schemes where the termination is to be remotely connected by a ribbon cable. A mating 50-Pin PCB connector 40-963-550-SM and IDC Breakout with DIN Rail mount 40-967-550-M are also available.
-
product
Cable Assembly, 50-Pin D-Type, Male to Unterminated With Ferrules, 1m
A050DM5-F-0A100
The 50-Pin Connector to Unterminated Cable Assy is constructed from PFA insulated wire and can be secured to the product by screwlocks. The 50-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
product
Cable Assembly, Receiver, QuadraPaddle, 72", 2 68-Pin Male Offset VHDCI
540205010529
Cable Assembly, Receiver, QuadraPaddle, 72", 2 68-Pin Male Offset VHDCI
-
product
PCIe to PXIe Remote Control Interface Cable, 2m
43-921-200
The 43-921 PCI Express-to-PXI Express expansion kit provides control of PXI Express modules installed in a PXI Express chassis using high bandwidth PCI Express technology. The extension kit can provide up to 4GB/s using PCIe Gen 2 x8 signalling. The 43-921 PCI Express-to-PXI Express expansion kit provides additional PXI instruments slots to the host computer by implementing a PCI Express-based control of PXI modules.
-
product
Cable Detectors
With certain models of cable detectors you can locate open power cables, either live or dead (without current), with voltages up to 300V. Cable detectors can locate cables, circuits, short circuits and ground points. To perform these functions, it is not necessary to disconnect electrically sensitive devices or to disconnect theCable Detectors to locate open power cables, either live or without current, up to 300V power from the cable which is being tested. Cable detectors can also locate ferrous and non-ferrous metals, wood and plastic with a high level of accuracy.
-
product
Cable Assembly, Receiver, TriPaddle, 20", 50 Pin ML D-Sub
540019020101
Cable Assembly, Receiver, TriPaddle, 20", 50 Pin ML D-Sub.
-
product
20-Pin GMCT Cable, Male to Male, 10A, 2m
A020GMR-020GMR-0B200
The 20-Pin GMCT cable assembly is constructed from 19/0.254 (18AWG) Tinned Copper Wire with PFA insulation. Screwlocks are provided to secure the connectors to their associated products. The 20-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
product
Cable Assembly, 50-Pin D-Type, Male to Unterminated With Tinned Ends, 1m
A050DM4-T-0A100
The 50-Pin Connector to Unterminated Cable Assy is constructed from PFA insulated wire and can be secured to the product by screwlocks. The 50-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
product
Cable Assembly, Receiver, TriPaddle, 36", 68-Pin Female SCSI
540083020203
Cable Assembly, Receiver, TriPaddle, 36", 68-Pin Female SCSI
-
product
Cable Modem Test Platform Version 2
Promptlink Communications, Inc.
CMTPv2 has broad support for all DOCSIS environments and even offers support for new higher-speed DOCSIS 3.1 devices. It continues support for all equipment vendors, impartially treating each vendor's devices with maximum performance and minimum hassle.
-
product
Cable Assembly, Receiver, TriPaddle, 20", 16-Pin Mini-Combicon Connector
540237010101
Cable Assembly, Receiver, TriPaddle, 20", 16-Pin Mini-Combicon Connector
-
product
Cable Assy 78-Pin D-Type F/F 1m
40-970-078-1m-FF
A 78-Pin D-Type cable assembly constructed from 7/0.15 (26AWG) Silver Plated Copper Wire. Screwlocks are provided to secure the cable to its associated products.
-
product
75 Ohm BNC to MCX Adaptor Assembly
40-978-781-0.1m
Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.
-
product
N-Male to F-Male Test Cable
C75NMFM
The C75NMFM is a high performance 75 Ohm test cable that is ideal for performing lab grade measurements 75 Ohm environments. It supports high accuracy testing with low insertion and excellent return loss up to 3GHz as well as outstanding mechanical durability.
-
product
Cable Assembly, Receiver, QuadraPaddle, 36", 68 Pin Male VHDCI
540120010240
Cable Assembly, Receiver, QuadraPaddle, 36", 68 Pin Male VHDCI
