Communication
The transmission of data from one computer to another, or from one device to another. (sbc.webopedia.com)
See Also: COMM, Communication Protocol, Spacewire
-
Product
Fixed Telephone Communication
-
PBE provides Fixed Phone Voice Communication for safe, efficient and reliable underground operation.Two-way voice communication underground is a necessity to provide a safe and productive work environment. PBE offers a number of fixed phone solutions that can be deployed to provide secure voice communications. Solutions can be analogue or digital and be either stand-alone or integrated into PBX and mobile infrastructure.PBE Fixed Telephones provide clear and undistorted communication throughout the entire underground phone system. PBE telephone networks are compatible with other analog and VoIP phones on the market today which allows to combine different products for a complete communication system above and below the ground.
-
Product
CPCI Integrated Communication Card
MS 3635I
-
CPCI Integrated Communication Card is high end Microprocessor based Mixed RS422 Communication and Differential Input & output Board. It is suitable for high speed Data Acquisition, Simulation, ATE applications. This board have Synchronous RS422 Communication Interface, Asynchronous RS422 Communication Interface, RS232, Ethernet interface and external bus interface. Board is well suitable for special type data acquisition & processing application. Board has high end FPGA which is used for automatic storage and very useful high speed data acquisition. Board is based on CPCI architecture and can be used with CPCI or PXI backplane.
-
Product
Communication Analysis System
ACQUA
-
ACQUA is a dual channel analysis system for diagnosis of acoustic and/or electric transmission paths up to 24 kHz. By means of predefined modifiable measurement descriptors measurement data can be gathered and evaluated in a simple and quick manner. All telecom specific analyses comply with the international standards of ETSI, ITU, TIA, 3GPP, GCF, PTCRB, DECT Forum, GSMA, CTIA.
-
Product
Isolated Serial Communication Card
PCI-ICM-1S
-
The PCI-ICM-1S is a single port asynchronous optically isolated serial communication card that can be installed in any 3.3V or 5V PCI slot computer. Data lines are opto-isolated from the computer and from each other to assure communication even when large common mode voltages and noise are imposed.
-
Product
Wireless Communication
-
The wireless communication devices are used when measured values have to be transferred from remote monitoring stations or mobile tanks to data collection centers. They also enable wireless remote diagnostics and maintenance of the connected sensors.
-
Product
Microwave Communication Trainer
-
We are instrumental in offering quality range ofMicrowave Products that finds application in satellite communication, broadcast and educational centers. Our range includes microwave test bench, critical microwave band & joint and MIC trainer. These products are known for optimum performance and high efficiency.
-
Product
Optical Communication Probes
-
Abacus Electrics ANSI Type 2 optical probes utilize infra-red LED technology to provide a galvanically isolated, bi-directional communications interface between energy meters and laptop computers or handheld devices for onsite data retrieval, programming and diagnostics.
-
Product
Optical Communication Analysis
-
In lab and manufacturing environments, R&D engineers require scalable and optimized test solutions to enable them to properly characterize new advanced modulation scheme signals for next-generation, ultra-high-speed telecom networks. Through EXFO’s optical communication analyzers, R&D engineers and manufacturing operations involved in the development or production of transmitters or systems based on new high-speed technology will find the right tools for their advanced technology needs.
-
Product
Optical Communication Parts
-
Adamant Namiki Precision Jewel Co Ltd.
Zirconia ferrule sleeve is an important part in optical fiber communication and is the basic product of our optical communication parts. We have developed an optical communication parts part of hasad developed based on grinding and bearings. Offer Optimum Performance And Quality For Each Type Of Optical Fiber, Optical Connector And Optical Device. We Also Offer Pin Gauges And Ring Gauges For Measuring Precise Dimensions Indispensable To Our Quality Assurance . These Gauges Have Little Wear, Good Compatibility With Ferrules And Sleeves, Zirconia , sapphire and cemented carbide are used as materials.Various Optical Connectors And Adapters Using Ferrules And Sleeves, Follow The Long History FC And SC Connectors, MU , LC Connectors Are Also Available. In Particular, LC Connectors Are Deployed In A Wide Lineup With Adapters. In The Field Of Optical Devices, We Provide Codes Master , Various Patch Cords , Conversion Adapters That Connect Different Types Of Connectors, Attenuators And Terminators That Provide Stable Characteristics, Which Are Manufactured Using The Ferrule Quality Of Our Own Manufactured Parts We Will. We Also Offer Parts For Optical Devices SuchAs Fiber Array Used For Connection Of PLC, AWG And Others. In The Field Of Optical Modules, SC And LC Receptacles , Fiber Stub, Pigtail Fiber And Other Optical Module Parts, And Now We Have Provided TOSA, ROSA And Other Optical Module Manufacturing Consignment Services. We Also Deal With Various Lensed Fibers Which Processed Fiber Tip With High Precision . In Addition, We Also Flexibly Deal With Precision Component Processing Used In Optical Communication Field, Special Specification Ferrule, Sleeve Etc. Please Contact Us.
-
Product
PCI Express Communication Card
ECU-P1524LSE
-
A specialized network interface device designed to provide zero-packet-loss, zero-recovery-time redundancy (IEC 62439-3) for critical infrastructure. It typically features 2-3 SFP ports for HSR/PRP, connects to a host system via PCI Express, and supports SR-IOV to enable multiple virtual machines (VMs) to share the card's resources for high-availability communication, often used in substation automation or industrial IoT.
-
Product
WiFi Communication Module
WiFi-201
-
The WiFi module is without doubts one of the most advanced and innovating elements of NeuLog. Measurements with NeuLog sensors can be performed through any device which uses the Wi-Fi technology, such as iPads and Tablets with Android, PC computers with Windows / Linux or Macintosh with OS. These can all communicate with the Wi-Fi adaptor to begin a unique experience of data acquisition.
-
Product
Communication Jammers
-
Stratign provides state-of-the-art customizable, active/reactive jamming solutions to block communication systems on the frequency band from 20-6000 MHz, in the targeted areas. We also enable the creation of an Authorised/Unauthorised list of cellphone users.
-
Product
Wire/ Wireless Communication
-
Wire/ Wireless Communication iDoor series focuses on Ethernet, WiFi/Bluetooth, GSM/GPRS and 4G/LTE solutions for data exchange in IOT applications.
-
Product
Measurement Data Wireless Communication Systems
-
Enables easy wireless data communication from a measuring tool to a PC Available at a lower price due to substantial cost reductions For detailed information‚ refer to the leaflet No. E12000
-
Product
3U CompactPCI® RS-232/422/485 Serial Communication Card
MIC-3955
-
The MIC-3955 is a low power 4-port or 8-port RS232/RS422/RS485 serial board with 3U CPCI form factor and is based on the EXAR PCI controller. MIC-3955 is PICMG 2.0 Rev. 3.0 compatible. Rear board module are named MIC-3527XX. The MIC-3955 supports front IO or rear IO with 4-port and 8-port, and every channel is independent.
-
Product
ProLink to 2.92mm Adapter with Probe Power and Communication Pass Through
LPA-2.92
-
ProLink to 2.92mm Adapter with Probe Power and Communication Pass Through
-
Product
8 Serial Communication Channels, Programmable RS-232/422/485 Non-Isolated
SC3
-
Serial Communication Module SC3 provides up to 8 high-speed, programmable RS-232, RS-422, RS-485, non-isolated communication channels. Each channel is programmable for either Serial Communications (SC) protocol or General Purpose I/O (GPIO) modes as either RS-422/485 (differential) or RS-232 (single ended) hardware level interfaces.
-
Product
Integrated USBL Acoustic Tracking and Communication Systems
-
The TrackLink systems are the world's best selling USBL acoustic tracking systems with fully integrated high speed acoustic communication capability. Capitalizing on its benchmark Broadband Acoustic Spread Spectrum (BASS) technologies, LinkQuest provides the end users with solutions for underwater tracking and communication at sharply reduced cost and increased robustness. An extensive line of models are available to suit the users' specification and budget constraint.
-
Product
1-Port Isolated RS-232/422/485 Communication EtherCAT Slice IO Module
AMAX-5090
-
Versatile Communication: The AMAX-5090 supports RS-232, RS-422, and RS-485 communication, making it adaptable to various industrial applicationsSeamless Data Transfer: With TxD and RxD channels and full/half-duplex capabilities, it ensures smooth and reliable data transmissionEffortless Integration: Interfaces for UART and Modbus RTU to EtherCAT simplify integration into existing systemsRobust Performance: Featuring a 1,000-byte receive and transmit buffer and a wide range of baud rates (1,200 to 115,200 bps), it guarantees efficient and high-speed data processingRugged and Reliable: Built for demanding environments, it operates in temperatures ranging from -25°C to 60°C and is compliant with RoHS standards
-
Product
Communication Unit For Digital Displacement Sensors
SC-HG1
-
Panasonic Industrial Devices Sales Company of America
Direct Transfer Of High-Precision Measurement Values: New Communication Unit For The HG-S Sensor Series
-
Product
FMC for Data Communication Dual 1 Gigabit Ethernet FMC
FMC431
-
Sundance Multiprocessor Technology Ltd.
The FMC431 is a dual 1 Gigabit Ethernet FPGA Mezzanine Card with two RJ45 connectors available on the front panel. Compliant with the VITA 57.1 standard the FMC431 offers a High Pin Count connector but is compatible with FPGA carrier cards with Low Pin Count connectors. The Ethernet interface (1000BASE-T) is either implemented using RGMII (Low Pin Count compatible) or SGMII (High Pin Count compatible). The FMC431 also offers the option to stack an additional FMC over it. Any of the 4DSP FMC that use LVDS and single ended signaling only can be mounted over the FMC431, thus offering users with the ability to build a complete data acquisition, waveform generation and communication solution while using a single FMC site on an FPGA carrier card. The FMC431 is an ideal solution to bring Ethernet connectivity to an FPGA based system and ensure reliable external communication.
-
Product
Handsfree Telephone Communication Tester
TestPhone 850
-
The TestPhone 850 provides both handset and handsfree telephone communication. The product provides a standard Public Switched Telephone Networks (PSTN) interface, user interface and handset and/or handsfree vocal interface to allow the user to originate or answer standard PSTN calls on both Dual-tone Multi-frequency (DTMF - tone dialling) and Loop Disconnect (LD - pulse dialling) lines. In addition the product features on-hook audio line monitoring, PSTN line polarity indication, automatic on-hook/power-off and integral ADSL digital line filtering.
-
Product
Communication Solutions
-
Bender provides a wide range of communication products to connect systems to facility technicians and management. A wide range of protocols are supported, ensuring interoperatibility with continually evolving technologies.Web browser interfaces and HMIs provide an easy-to-use gateway to your system. Integratable communication brings Bender into your industrial network. Cloud-based solutions provide a scalable, secure solution for system status and analytics across multiple facilities and locations.
-
Product
Industrial Communication
-
Reliable data flow and transparent communication across all production processes have become indispensable in automation. The main goal of industrial communication is to integrate all plant areas from the control to the field level in a networked system. Because consistent and powerful data networks increase the availability and efficiency of machines and systems.
-
Product
Network Communication Platform Peripheral
-
Axiomtek provides different add-on cards for network appliance, such as PCIe PoE cards, network security cards, IPMI and more.
-
Product
3U CompactPCI 8-port Serial Communication Module
cPCI-3548
-
- Supports 32-bit/33MHz CompactPCI bus- 16C550A compatible serial communication controller- Eight RS-232/422/485 asynchronous communications ports with intelligent buffer- 2500 VDC signal to ground isolation voltage- Auto-flow control; change mode by dip switch- Plug-and-play, IRQ & I/O address automatically assigned by PCI BIOS, shared IRQ- Surge protectors; rugged DB-62 connector
-
Product
Communication Protocol Test Harness
-
Simulate Master or Outstation Devices.Monitor Communications.Create Custom Functional Tests with any .NET programming language, Python, or Tcl/Tk scripts.Exercise a device as it will be used on the utility SCADA network.Automatically Perform Conformance Test Procedures.
-
Product
Test Tool for Modern Wireless Communication Devices
ITN 1000 for WLAN and Bluetooth™
-
Functional Test Tool for Modern Wireless Communication DevicesDevelopment, prototyping, validation and production testing of wireless devices supporting the Internet of Things need low cost, easy-to-use test equipment with support for the latest standards:- Wi-Fi 6E: 802.11ax, 2×2 MIMO; 2/5/6 GHz - Bluetooth™: 5.2 BDR/EDR/BLE
-
Product
LTE RF Communication Subsystem
-
The Delaire USA LTE RF Communication Subsystem is designed to provide a versatile solution for the testing needs of the next generation wireless systems. With the LTE test subsystem developers can build an end-to-end test environment for complete system operation. From end user equipment and eNodeB base stations to full system functionality, the LTE RF Communication subsystem allows developers to test and evaluate equipment and system performance in a controlled laboratory environment.





























