Product

Bias Tees & DC Blocks

-

Pasternack Enterprises, Inc.

Pasternack Enterprises, Inc.

Your product description goes here.

Product

RF Bias Burn-In System

-

Accel-RF Corporation

Accel-RF Corporation

These systems deliver an unbeatable combination of advantages over a wide range of RF frequencies and power levels. The Automated Multi-Channel RF-Biased Burn-In Test System is a turnkey system that incorporates all of the capability needed for accelerated aging and parametric testing of RF semiconductor devices. Its powerful software elegantly supports data acquisition, storage, and presentation. Accel RF’s customers choose system features to meet their technical needs and capital budget. In addition to cost savings, use of Accel-RF’s solutions accelerate product time-to-market, saving many months of product development.

Product

Adaptative Body Bias (ABB) IP

-

DOLPHIN Design

DOLPHIN Design

A revolutionary FD-SOI bias generator enabling real-time corner compensation:- Up to 10x energy efficiency gains at low VDD- Foundation IP independent- Seamless integration

Product

Bias Tees

-

Kuhne electronic GmbH

Kuhne electronic GmbH

A bias tee is a three-port network used for setting the DC bias point of some electronic components without disturbing other components. The bias tee is a diplexer.

Product

Bias Tees

-

Pasternack Enterprises, Inc.

Pasternack Enterprises, Inc.

Pasternack Bias Tees

Product

External DC Bias Adapter

16200B

-

Keysight Technologies

16200B - Keysight Technologies

The 16200B test fixture is designed to operate with high frequency LCR meters and impedance analyzers. It allows you to supply a bias current across the device of up to 5 Adc through a 7 mm port by using an external DC current source.

Product

Bias Tees From 0.03 MHz To 85 GHz

-

Pulsar Microwave Corporation

Pulsar Microwave Corporation

Pulsar offers a large variety of bias tees that cover frequencies from DC to in both surface mount and connectorized packages. Many models are available with voltages up to 100 volts and currents up to 8 amps and custom requirements are welcomed. Options include higher voltage and current, higher RF input power and a choice of either an RF connector or a feedthrough connection for the DC input port.

Product

High Power Switch and Bias Module

-

Macom Technology Solutions Holdings Inc.

Macom Technology Solutions Holdings Inc.

MACOM’s High-Power Switch and Bias modules are extensively used in 4G and 5G TDD base stations as well as aerospace and defense applications. The PIN Diode Switch features high power handling, low insertion loss, and super board band performance. The integrated bias controller utilizes a boost circuit and provide the driver circuitry to the switch. The modules require only a single 5 V supply, and a single TX / RX control signal which greatly reduced the customer design complexity.

Product

DC Bias Injector

J2130A

-

PICOTEST Corp.

J2130A - PICOTEST Corp.

When using the network analyzer to measure impedance, such as the capacitance and ESR or a capacitor, or the DCR of an inductor, etc., it is often necessary to provide a voltage bias to the device being tested. This is true of semiconductor junction capacitances, varactors, and some ceramic capacitors (especially X5R). In these cases the impedance is a function of the DC bias on the device. The Picotest DC bias injector (J2130A) is used for this purpose during impedance measurements.

Product

Low-Noise DC Bias

-

Pulse Instruments

Pulse Instruments

Imaging devices, such as CCDs, IR FPAs, and CMOS image sensors, require DC bias with very low electrical noise to prevent contamination of the image. Image quality can also be enhanced by carefully tuning each bias voltage to extract the maximum signal/noise ratio out of an array. Pulse Instruments has decades of experience providing DC bias supplies with the flexibility required tocharacterize and test a variety of devices while maintaining the noise immunity required for satellite and astronomy applications.