Filter Results By:
Products
Applications
Manufacturers
ASIC
Application Specific Integrated Circuits are application specific custom made ICs.
-
product
Digital Fiber Sensor
FX-500 Ver.2
Panasonic Industrial Devices Sales Company of America
Thanks to its new “application-specific integrated circuit” (ASIC), Panasonic can solve applications with Fiber Optic Sensors that were previously impossible. Not only can the FX-500 Series reach a response time of 25µs while providing extremely accurate detection, integrated logic functions save you money because external controllers are no longer needed for normal applications and threshold tracking and self-diagnostic functions save time for maintenance. Moreover, the reliability of the detection has increased by 75% compared to that of previous models.
-
product
Digital Pattern Generator
Wave Gen Xpress
A digital pattern generator is an essential stimulus source for almost every type of digital device: digital and mixed-signal ASIC, FPGA, microprocessors and microcontrollers. The digital pattern generator can be used early in the design cycle to substitute for system components that are not yet available.
-
product
Rad-Hard ASIC Platforms
STMicroelectronics, a leading supplier of digital CMOS technologies, is bringing differentiation by developing advanced deep-nanometer radiation hardened technologies dedicated for the Space, Aerospace and High-Rel & Defense markets.
-
product
GRIDSCAN 5000
Hydrogen Series
The H2scan GRIDSCAN 5000 Hydrogen Sensor pairs a high performance ASIC to H2scan’s field-proven solid-state hydrogen sensor. This stand-alone sensor system has been designed to provide precision hydrogen measurement, at a lower cost for the high-volume OEM or utilities. No calibrations or maintenance is needed for up to 10 years, and the GRIDSCAN 5000 is the lowest cost by thousands to any other available hydrogen DGA system. H2scan is the only company in the industry that can state retail sales of over 15,000 sensor systems worldwide with no after sale calibrations performed since 2012.
-
product
MEMS Microphones
A MEMS microphone is an electro-acoustic transducer housing a sensor (MEMS) and an application-specific integrated circuit (ASIC) in a single package.
-
product
PCI Express IP
Rambus silicon-proven, high-performance PCI Express® (PCIe®) 6.0, 5.0, 4.0 and earlier generation digital controllers are optimized for use in SoCs, ASICs and FPGAs. These market-leading solutions for high-performance interfaces address AI/ML, data center and edge applications.
-
product
Rad Hard Power
Renesas' radiation hardened (rad hard) power products achieve the stringent voltage accuracy required of FPGAs, ASICs, microprocessors, and microcontrollers used in space and harsh environment applications. Our solutions enable regulation accuracy over input voltage, load current variation, switching noise, and large load transients and have proven highly reliable within mixed radiation exposure rates and other harsh environment variants.
-
product
Network Switches
Our switch fabric modules provide full service switching through hardware accelerating ASICs from leading device makers including Mellanox or may be software defined for upgradability. These high bandwidth switches include system management capabilities including full compliance with VITA 46.11.
-
product
ASIC / COT / FPGA Design
EL & Associates, Inc. specializes in integrated solutions for design (RTL to GDSII), Design-For-Test (DFT) and Design-For-Manufacturing (DFM) services for ASIC, ASSP, COT, and FPGA. We engage with customers from RTL phase to silicon prototype. The ELA methodology is optimized to manage risk in design, manufacture and product deployment. ELA has successfully completed over 750 designs to date.
-
product
Power Bead Inductors
Power bead inductors are typically used in high current multi-phase voltage regulators that power processors, memory modules and high current ASICs and FPGA in a wide range of applications including servers, graphics cards, storage and data centers. The construction consists of a ferrite core assembled over a 1T or 2T winding and which allows for extremely low DCR, high peak current and low AC losses. Pulse has single phase, integrated phases and coupled inductor versions. Our high volume manufacturing enables us to produce components that are cost-effective while maintain exceptional quality and reliability.
-
product
360 EC-ASIC
ASIC synthesis verification from RTL code to final netlist.Systematic design errors, introduced by automated design refinement tools, such as ASIC synthesis, can be hard to detect, and damaging if they make it into the final device. Formal Equivalency Checking (EC) has become a standard part of the ASIC development flow, replacing almost all gate level simulation with a rigorous consistency check between pre- and post-synthesized code.
-
product
Linear Array Detector Cards
X-Card 0.2 to 2.5mm
A product family of high performance linear X-ray detector cards with preamplifier ASICs. The preamplifier ASIC converts the charge output from the photodiode array into voltage with serial output for easy integration with readout electronics. Can be arranged end-to-end to form large linear detector arrays.
-
product
Component Test and Analysis Laboratories
The Component Test and Analysis team specializes in electronic and mechanical components such as hybrids, connectors, cables, harnesses, passive or discrete components, and digital or linear devices. The test lab has extensive experience in developing test software to electrically and environmentally characterize virtually any integrated circuit, including analog, digital, mixed signal, converters, FPGA and ASICs, as well as experience in developing actual radiation environments for parts testing. The component analysis team offers the analytical expertise and advanced instrumentation to identify root cause explanation for a wide range of component-level failures, as well as the resources to evaluate for possible quality and reliability issues through non-destructive and destructive techniques. With access to a detailed database, the Component Test and Analysis team offers a 25-year history of test and analysis data — a valuable resource for addressing new customer requirements.
-
product
Motion Control Solutions
DDC offers a complete line of Synchro/Resolver instrument-grade cards and test equipment including angle position indication and simulation, plus a variety of hardware and software to meet today’s civil, military, and COTS/MOTS requirements. DDC is a leading supplier of Synchro/Resolver-to-Digital and Digital-to-Synchro/Resolver components—the smallest, most accurate synchro/resolver-to-digital and digital-to-synchro/resolver converters available today. Most of these single chip and hybrid converters are based on ASIC designs, yielding the most reliable and affordable converters ever offered, and are the building blocks for DDC’s card-level products.
-
product
ASIC Testing
Silicon Turnkey Solution, Inc.
As ASIC designs increasingly become more complex, so does the testing process—in fact, it can even be the bottleneck that constrains the total design cycle time and therefore impacts time to market. Effective and accurate testing requires in-depth knowledge of the hardware design itself as well as the software skills to conceive and create the appropriate test programs.
-
product
PCI Express 4 Base Specification Receiver Test Automation
N5991PB4A
The N5991PB4A is the receiver test automation software for bit error ratio testers, allowing you to test and characterize PCI Express 4.0 ASICs.
-
product
Universal PMICs
PowerArchitect™ design and configuration software speeds development and significantly reduces overall time-to-market compared to legacy analog power solutions. An I²C interface and multiple GPIO pins ensure easy system integration. Configurable warning and fault levels, fault behavior and power up and down sequencing ensure any load can be properly powered and protected. The power system design can be completed with confidence long before the final revision of the SoC or ASIC is available.
-
product
Ultrascale FPGA PCIe Board
SE100 – Solar Express
Sundance Multiprocessor Technology Ltd.
SE100 is based on Xilinx’s Virtex Ultrascale FPGA XCVU190-2FLGC2104E, and is a powerful processing card with plenty of IO capabilities to meet the needs of modern compute-intensive applications such as Supercomputing, Data Centers and defense. The board can optionally be populated with 095, 125, and 160 devices in C2104 package for reduced cost. Host interface is via 8 lanes of PCIe Gen3 but the card can also be used as an embedded, standalone, hardware too. Multiple cards can be cascaded to provide a multi-FPGA system with cards connected together via the board’s fast IO channels to meet the needs of even more demanding applications like ASIC design and Stock Market fast trading systems.
-
product
Audio MEMS Sensors
An audio MEMS sensor is an electro-acoustic transducer housing a sensor (MEMS) and an application-specific integrated circuit (ASIC) in a single package.
-
product
PCI Express 5 Base Specification Receiver Test Automation
N5991PB5A
The N5991PB5A is the receiver test automation software for bit error ratio testers, allowing you to test and characterize PCI Express 5.0 ASICs
-
product
Function Generators
Waveform : Sine, Triangle, Square, Pulse, Sawtooth, Ramp 0.2Hz-150MHz EXT Frequency Counter(Option : 1:6 GHz or 2.7GHz) Self made insert ASIC Function : Total, RPM, Period, LPF, COUPL(AC/DC), ATT(X10) Fast,High-Resolution, 8Digits LED display Internal or External AM,FM Modulation Internal or External Burst and Linear Sweep Countrol from 1 : 1 to 100:1 TTL/CMOS Leveled Square Wave Output Maximum Attenuation of 20 dB cna be obtained Output impedance : 50 INPUT SENSITMTYKHz Range : 100mVms, MHz Range : 300mVms SWEEP WIDTH : Variable from 1:1 -100:1 RATE : 0.5Hz - 50Hz(20ms-2s) INTERNAL : Linear Bilt-in 5digits Green LED display
-
product
Complete IP Module
Scan Ring Linker SRL
The Scan Ring Linker SRLTM - is a complete IP module that can be easily embedded into a CPLD, FPGA or ASIC on a PCB to reduce the complexities and costs of designing 1149.1 (JTAG) test infrastructure for designs that use multiple scan rings. The SRL IP module links any number of scan rings (secondary scan paths) into a single high-speed test bus, which permits devices on secondary scan chains to be independently tested and configured through a single 1149.1 external interface.
-
product
Constraints Certifier Platform
ConCert
ConCert is a sign-off platform providing a unique system for verification, demotion and budgeting of timing constraints at any stage of the ASIC or FPGA flow.
-
product
Video CODECs
ADV7202
For designers requiring complementary high precision, high speed video digital-to-analog and analog-to-digital converters, Analog Devices offers a single generation of video codecs. Designed to provide analog video input/output capability for proprietary video systems, ASICs, or FPGAs, the ADV7202 supplies raw video conversion and basic analog signal processing and conditioning to allow highly efficient, well partitioned systems architecture.
-
product
Functional Testing
Functional Ethernet testing is done during the research and development phase of a product or service. It can cover many parameters depending on the DUT and the application. Using Xena’s products, your range of functional Ethernet testing includes:*Multicast*40/100G PCS and PMA Layer*Transparent Transport*Energy Efficient Ethernet (EEE)*Microbursts and random IFG*Synchronous Ethernet*Automotive Ethernet*1588v2 Performance Testing*Regression testing*Kernel drivers and NIC testing*Hardware emulation (ASIC*)
-
product
STP Engine (IP Core)
The Stream Transpose® (STP) engine is a reconfigurable processor (DRP: Dynamically Reconfigurable Processor) core that combines the flexibility of software and the speed of hardware. The firmware defining processing can be reconfigured in an instant, allowing an almost infinite variety of functions to be integrated into a system. A 40nm process is currently available for ASIC.
-
product
Wafer Probe Test System
STI3000
The STI3000 is a wafer-level MEMS and mixed signal ASIC probe test system that combines several functional STI test equipment blocks for testing gyros, accelerometers, pressure sensors, microphones, resonators, and mixed signal ASICs.
-
product
CompuScope GPU CUDA Processing
Performing real-time digital signal processing (DSP) routines such as Fast Fourier Transform (FFT), Signal Averaging, Finite Impulse Response (FIR) Filtering, Digital Down Conversion (DDC) and more have traditionally required the use of dedicated DSP processors, Field Programmable Gate Arrays (FPGAs), or Application Specific Integrated Circuits (ASICs).
-
product
ARM Development Studio 5
DS-5
ARM DS-5 is the tool-chain of choice for software developers who want to fully realize the benefits of the ARM Architecture. Comprising features such as the best-in-class ARM Compiler, powerful OS-aware debugger, system-wide performance analyzer, and real-time system simulator, DS-5 is an integrated development environment that assists engineers in delivering optimized and robust software for ARM processor-based ASICs and ASSPs.
-
product
EMBEDDED MMC (EMMC)
SD 3.0 / eMMC 4.51 IP Family
The eMMC Host IP is an RTL design in Verilog that implements an MMC / eMMC host controller in an ASIC or FPGA. The core includes RTL code, test scripts and a test environment for full simulation verifications. The Arasan MMC / eMMC Host IP Core has been widely used in different MMC applications by major semiconductor vendors with proven silicon.
