Filter Results By:
Products
Applications
Manufacturers
-
product
Compact Monitoring Probe
DVB-C
EdgeProbe Nano is the most tiny and compact digital cable standalone analyzer, with no compromise on Quality, used for continuous monitoring of critical RF, MPEG-2 TS or C2 frame parameters and health diagnosis of cable networks.
-
product
VXI-Based Monitoring Solution
R&S®AMMOS® GX400
The R&S®AMMOS® GX400 solution is designed for detection, monitoring and signal analysis of radio communication signals in the HF & VHF/UHF frequency range.
-
product
Panel for Energy Monitoring
Energy Box
The box allows a quick installation of the energy monitoring and remote control system Ducknet
-
product
Logger and Handheld Instruments for Temperature Measurement and Monitoring
Temperature measurement and monitoring is vital for the quality of temperature-sensitive products wherever they are studied, produced, stored or transported.
-
product
Arc Flash Monitoring
Arc fault protection for the fast clearance of arcing faults on BUS bars & within metal clad switchgear & associated cable boxes. The arc is detected using an optical sensor & the signal input to a protection device which alsomonitors the load current on the system.
-
product
Fixed Aperture RF Current Monitoring Probe
TBCP1-200
The TBCP1-200 is a fixed aperture RF current monitoring probe.The probe has a 3dB bandwidth of approximately 200 MHz. The aperture of the RF current monitoring probe is 25 mm. Its transfer impedance is > 14 dB Ohm in the range from 40 kHz to 200 MHz.
-
product
Data Monitoring System
1S663-001
The 1S663-001 Data Monitoring System was specifically developed for the Cessna Citation X and serves as the primary diagnostic tool for the aircraft?? electronic Logic Modules. The system is FAA certified for airborne operation. Aft compartment and cabin modules can be tested two at a time while remaining in place. The system is also capable of monitoring the fuel quantity system during flight.
-
product
Protective Relay Test Kit
PW460
PW460 Protective Relay Test Kit is the comprehensive protection relay testing equipment for all types of protective relays with high accuracy. This relay test kit has in-built output monitoring and recording function and supports testing IEC 61850 digital relay.
-
product
Custom Shaft Torque Sensor Solutions
We also offer rotary power sensors, rotary torque sensors and torque meters that are capable of measurements above our standard range of 20,000NM to meet the needs of our customers within a commercial environment.Our standard torque sensor range incorporates the measurement of torque up to 60,000Nm, these provide solutions to most test and monitoring requirements.
-
product
LXI Video RF Multiplexers
Pickering's LXI Video RF multiplexers, high performance MUXs suitable for video switching applications designed for the switching of RF signals in 75 systems at frequencies up to 1GHz. These multiplexers are also ideal for 75 monitoring applications that require a multiplexer to select one channel to be routed to measuring equipment.
-
product
Stationman Speaker Probe
250 SSP
This probe is designed for those technicians that want the best tool available. The Model 250SSP is supplied with a cone-shaped tip and a duckbill tip that is longer and flatter, permitting insertion into larger cables, or cables under tension where slack cannot be obtained. Another feature is the built in speaker for audio without the need for a butt set or headset. The speaker is operated by a slide switch that has a "lock" position for continuous monitoring.
-
product
Event Analyzer
The SIGNAL Event Analyzer represents a breakthrough in the analysis of repetitive acoustic events as diverse as field recordings of birdsong, laboratory ultrasonic rodent vocalizations, and industrial monitoring of rotating machinery. It can go automatically from raw acoustic data to summary behavioral acoustic measurements and statistics, such as call rate, call duration, intercall interval, peak frequency, frequency range, etc. Compared to manual event editing and measurement, the Event Analyzer allows the researcher to investigate many more acoustic parameters for significant effects, with a much larger data sample, and, if desired, over a much longer time period.
-
product
Aluminum Portable Telemetry System with Integrated Keyboard and Display
LS-84-AP
The Lumistar LS-84-AP Rugged Aluminum Portable Data Unit offers a low cost, high performance COTS solution for aportable quick look ground station. Lumistar LS-25 FMReceivers or LS-25-D2 Down Converters with LS-35-R Multimode IF Receiver, Bit Synchronizers and Multi-function PCM Decommutators, and LS-71D/A Converters can be installed inthis rugged high quality portable computer and bundled with theLumistar setup, control, and monitoring software to achieve anaffordable alternative to the often expensive, proprietary architecture products of other suppliers. The flexible design allows the user to define the desired data acquisition cardconfiguration to unique requirements.
-
product
Monitoring System
TriGas X5000
The TriGas X5000 Monitoring System is an integrated gas detection solution that helps plant operators comply with NFPA 820. The system monitors for combustible gases, hydrogen sulfide and oxygen with on-board alarming and communication interface to plant and remote location control stations.
-
product
Epi Thickness & Composition
FTIR (Fourier Transform Infrared) is the most important technology for measuring epitaxial film (Epi) thickness, measuring impurities in Silicon and monitoring dielectrcis, like Borophosphosilicate glass (BPSG), FSG, PSG, etc in semiconductor industry. FTIR is evolving from a primarily quality control (wafer supply chain) technology to a tool/process/chamber (test wafers) monitoring technology and more importantly, a device (product wafers) monitoring tool.
-
product
Application Performance Management
Enterprise-class testing and monitoring platform for websites, applications and APIs. Internationally distributed load testing and monitoring agents can regularly and programmatically check your targeted websites. web applications, API services, authentication services, certificates, DNS services, and more for performance and service-level compliance.
-
product
Chemiluminescence 03 Analyzer
Model T265
Teledyne Advanced Pollution Instrumentation
The Model T265 is the only commercially available US EPA Federal Reference Method for Ambient Ozone Monitoring according to the latest US EPA regulatory rules for O3. The instrument uses Chemilumescence with Nitric Oxide (NO) as a reagent, making is safe, stable, and effective for all applications. The NO-CL method for Ozone has several advantages over the conventional UV absorption technology, including the avoidance of positive and commonly found interferrents such as VOCs, fine particulates, Mercury, turpines, ClO2, and others. If these pollutants are present in the atmosphere, it can cause UV absorption analyzers to give an artificially high Ozone measurement. The innovative T265 combines speed of response, sensitivity and stability of our proven nitrogen oxide analyzer, with a simple user interface, to provide reliable ozone measurements under the harshest conditions.
-
product
Biosensor isoPod
EP352
A compact signal conditioner for monitoring low current, two-electrode (anode and cathode) amperometric sensors.Electrical isolation ensures that readings are not influenced by nearby current sources such as conductivity, or voltammetric electrodes.
-
product
Passive Diagnostics Solution
EtherTAP2
EtherTAP2 is a monitoring interface that enables the in-depth analysis of PROFINET and EtherNet/IP traffic. Just like its highly popular predecessor, it acts as a bridge between your industrial network and our Osiris diagnostics platform. However, its newly designed housing and improved functionality guarantee the early detection of communication errors and give round-the-clock access to passive diagnostics.
-
product
Current Loop Adapter
OP-1C
This adapter supports current loop communications.The kit incorporates a communications circuit with photo-coupler isolation and constant-current power supply of insulated type, thus realizing not only monitoring but also easy communications testing with passive or active current loop devices.
-
product
FTB Ecosystem
Imagine test tools that actually help you deliver services with speed and quality. Imagine if you could institutionalize operational efficiencies, eliminate silos and make every component of your deployment, turn-up and monitoring part of one tightly woven fabric.
-
product
Portable Measurement Solution
MOSS model
Its pragmatic design means it is practical and simple to use, its adaptable multi-sensor functionality gives you the freedom to develop your own Marine Operation Survey and Monitoring solutions.Some basic examples are:Inclining experimentsFreeboard measurementSalvage survey and monitoringDry docking operationsField pressure testingAny field operations...
-
product
Most Versatile All-in-One Medical Panel Computer Family with Selectable 8th Generation Intel® Core™ Processor Performance
MLC 8-21/23/27
ADLINK’s new series of MLC 8 medical computers with 8th generation Intel® Core™ processors delivers high computing performance and outstanding graphics processing capabilities. The MLC 8 series are designed with optimum viewing capabilities and hygienic, fully-sealed and easy-to-clean housings. They can be used for patient’s vital sign monitoring, nursing care, clinical diagnosis, PACS (Picture Archiving and Communication System), anesthesia monitoring and operating room documentation. With additional safety design and expansion capabilities, our medical panel computers and monitors provide a reliable and flexible system with high usability and convenience for doctors and hospital staff.
-
product
Waterproof Infra-Red Turbidimeter (NTU) with calibration kit
TN 100
The microprocessor-based waterproof TN100 meter is an easy-to-use turbidimeter that meets the rigor of rugged field applications. It is a "must -have" for anyone monitoring turbidity on the go. Using an Infrared light source, it delivers laboratory accuracy with a resolution of 0.01 NTU across an extended range of up to 20 NTU (Nephelometric Turbidity Units).
-
product
10 MHz to 6 GHz/33 GHz LAN Power Sensor
U2049XA
Wide dynamic range (-70 to +20 dBm) for small signal measurements LAN/ Power-Over-Ethernet (PoE) connectivity for long distance remote monitoring (up to 100 meter)TVAC compliant for operation in vacuum Best-in-class long term drift performance Internal zero and automatic calibration saves time and reduces measurement uncertainty Easy measurement start-up with new intuitive BenchVue software
-
product
Evaporative Emissions Testing
GASERA ONE SHED
Evaporative losses from the fuel system are tested for vehicle certification. GASERA ONE SHED allows direct monitoring of evaporative emissions as part of the qualification testing procedures for vehicles. The GASERA ONE SHED’s photoacoustic technique is approved by the Environmental Protection Agency (EPA) and the California Air Resources Board (CARB).
-
product
ESS Performance Test System
The Energy Storage System (ESS) Performance Test System is used to evaluate, test, and certify the performance of energy storage systems up to 2MW. The system is a configurable platform with over 200 channels of simultaneously measured AC and DC voltages and currents, environmental temperatures, airflow, and communications. Intuitive software provides real-time monitoring and analysis of power, energy and efficiency to adhere with industry standards. The test system interfaces hardware such as load banks, and controls the ESS to simulate utility applications such as peak shaving and frequency regulation.
-
product
Portable Emissions Analysers
Portable Automated Monitoring Systems, P-AMS or PEMS, such as Protea’s FTIR and TDL analysers allow for a wide range of industrial pollutants to be measured periodically or as a back-up to existing CEM systems.
-
product
Advanced Trace Analysis System
VQcapture
VQcapture™ is a streamlined packet capture import and analysis utility incorporating Telchemy's VQmon® performance monitoring technology. It offers a simple yet sophisticated CLI-based tool for analyzing the performance of VoIP calls and IP video sessions, and can provide comprehensive Layer 2/3/4 packet metrics and traffic/usage statistics for a range of network applications and services
-
product
Energy & Process Monitor
Real time monitoring and reportingComposite system with EMS and PEMSDesired reports like, Doff wise, shift wise, count wise, production, energy, UKGSpeed Vs Kw curve, trends, bar graphs, comparisonsAlerts on higher UKG, lesser production, utilization & power fluctuations.Maintenance alerts based on run hours production cost analysis - Cost Audits - Energy Audits
